Sealey SX299RR Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! DO NOT use the tool if damaged or thought to be faulty.
‰
WARNING! Ensure that Health & Safety, Local Authority Regulations and general workshop practice Regulations are adhered to
‰
when using tools.
DO NOT use the tool for a task it is not designed to perform.
8
DO NOT use the tool unless you have been instructed in its use by a qualified person.
8
DO NOT operate the tool if you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
Maintain the tool in good condition.
9
Follow all workshop safety rules, regulations and conditions.
9
Wear eye protection, protective gloves and safety footwear.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
9
Keep children and non essential persons away from the work area.
9
2. INTRODUCTION
Specially designed cutter for use on Land Rover, Range Rover locking wheel nuts. To be used in conjunction with Model No. SX299
Master Locking Wheel Nut Removal Set.
3. CONTENTS
No. Description
1 Outer shroud
2 Key
3 Mandrel
4. OPERATION
4.1. TOOL ASSEMBLY
4.1.1. Slide outer shroud (fig.1.1) fully down over remover tool body (NOTE: An 'O' ring is used to make this a tight sliding fit).
4.1.2. Insert key (fig1.2) into tool body. Engage and clip in place using the spring ring in tool body.
4.1.3. Slide outer shroud (fig.1.1) up over the spring ring to prevent it expanding and the key becoming loose.
4.2. USAGE PREPARATION
4.2.1. Check that the splines (front and back) on the locking wheel nut are aligned.
4.2.2. If not aligned, insert the mandrel (fig.1.3) into the key (fig.1.2) and locate the key splines with the front splines of the locking wheel
nut.
4.2.3. Rotate the tool to align front and rear splines.
4.3. OPERATION
4.3.1. Once aligned, remove the mandrel (fig.1.3) and replace key onto locking wheel nut ensuring re-location of key onto the rear splines
of the locking wheel nut.
4.3.2. Using the impact driver (SX299.V2-01) gradually increase the impact effort ensuring sufficient engagement of the key to the rear
splines of the locking wheel nut.
4.3.3. Using the impact drive socket (SX299.08) loosen and remove the locking wheel nut.
5. MAINTENANCE
5.1.
Clean with lightly oiled cloth before storing after use.
© Jack Sealey Limited
RANGE ROVER CUTTER FOR SX299 MASTER
LOCKING WHEEL NUT REMOVAL SET
MODEL NO:
Wear protective
Wear safety
gloves
footwear
Original Language Version
SX299RR
fig.1
SX299RR Issue 1 28/04/20