Intensity Levels; Battery Status (When Handle Is Not On Charger) - Philips Sonicare 5 Series Manual

10
English
Note: When the Philips Sonicare is used in clinical studies, the default
2-minute Clean mode with high intensity must be selected. The
handle should be fully charged and the Easy-start feature
deactivated.
Brushing modes
Clean mode
The ultimate in plaque removal (default mode). Clean mode lasts for 2
minutes and includes four 30 second Quadpacer intervals.
Gum Plus mode
To gently stimulate your gums. Gum Plus mode lasts for 2 minutes
and includes four 30 second Quadpacer intervals.
1 Press the power on/off and mode button to turn on your Philips
Sonicare.
2 Press the power on/off and mode button again within 2.5 seconds
to switch to Gum Plus mode.
3 Press the power on/off and mode button after 2.5 seconds to
pause your Philips Sonicare

Intensity levels

- Low: 1 LED indicator light
- Medium: 2 LED indicator lights
- High: 3 LED indicator lights
Note: To adjust the intensity level to the next higher or lower level,
press the + intensity level button to increase intensity or the -
intensity level button to decrease intensity at any time during the
brushing cycle

Battery status (when handle is not on charger)

- A flashing yellow battery level indicator indicates a low charge.
- A flashing green battery level indicator indicates a moderate
charge.
- A solid green battery level indicator indicates a full charge (Fig. 6).
Note: If you hear 5 beeps and the battery level indicator flashes
yellow, this means that you have to recharge the battery. When the
battery is completely empty, the Philips Sonicare turns off. Place the
Philips Sonicare on the charger to charge it.