Table of Contents
Advertisement
Keep Warm
It will automatically change to the heat
preservation mode after cooking.
Please note that during heat preservation,
Please do not leave serving spatula in the pot (It will release unpleasant odor)
Please do not keep cold rice in for heat preservation (It will release unpleasant odor)
Please do not turn off keep warm function when there is rice in the pot(It will release unpleasant odor)
Do not keep warm for more than 8 hours (or else it will produce unpleasant odor)
Start heat preservation from the closing state
KEEP WARM
REHEAT
Start heat preservation after
pressing KEEP WARM button
KEEP WARM light turns on
Warm
To check the current time
preserving
Press during heat
preservation
It will display the current time after just
pressing down
Technique
To prevent rice in heat preservation from being sticky, please do not leave rice grains on side of the inner
for heat
cooking pot. Besides, please stir the rice frequently.
preservation
It's better to keep in refrigeration with cling film if "the heat preservation may be too long" or "there is a little
rice".
20
To keep the rice tasty during heat preservation, it will
automatically control the heat preservation temperature
based on using conditions.
Press down CANCEL button to stop the heat preserva-
tion.
KEEP WARM light turns off, and the display content is
switched to the current time)
Take out the inner cooking pot to automatically cut off
the heat preservation.
To reheat the rice in heat preservation,
(Ignore for models without this function)
Scarify rice in heat preservation and
close the outer cover
Press KEEP WARM button to start to
reheat
(25 Minutes)
It ends when buzzing
(recovered to heat
preservation state)
KEEP WARM light flickers during reheating, and
display the time left before ending.
Reheating after heating pause
Press KEEP WARM button and recover to the heat
preservation state.
Please do not conduct the following reheat.
Repeat reheating (will make rice dry and yellow)
Cold rice reheating (will send out unpleasant odor)
Too much rice will make it impossible to fully heat. (It
shall be below about half the inner cooking pot)
Maintenance
Please
An unplesant odor will produce due to inappropriate
note
cleaning process.
Note
Please do not use the following items
tion, corrosion, discoloration, crack or scratch)
During maintenance, the power plug
Tableware washing dryer and tableware dryer
should be unplugged. The body
Detergent other than neutral detergents for kitchen
should be maintained after cooling.
Gasoline, thinner, alcohol, cleanser and bleach
Grinding surface of nylon pot-scouring brush, melamine sponge and other
Otherwise, it will cause scald
items easily causing scratch
After using inner cooking pot, detachable inner lid, steam valve and serving spatula and
measuring cup getting dirty every time
Wash with sponge and neutral detergent
Wash the detachable inner lid promptly after adding seasoning
for cooking. Otherwise, it will get rusty.
for kitchen
Wipe off foreign matters or dirt with dried
duster cloth
Please do not wash the entire body.
Please do not spray water to operating parts or covers, or add
water into the outer casing cover.
Please do not pull or drag washer of steam valve. (Impossible to
fall down due to fixing)
When there is dirt on temperature sensor
Slightly friction with fine sandpaper (about No.600),
and then wipe off dirt with dried clean duster cloth.
Opening buckle plate, suction port and exhaust port (bottom of the body)
Clean up foreign matters or dusts with cotton rod or others.
Opening buckle plate
Steam
Clean inside
Wipe off water after using every time
steam valve
valve
Dirt in steam valve will cause rice scent and spill.
Steam valve cover
Besides, there may be water drops in the case of spilling or opening the upper housing.
There will be water generated from cooled steam inside steam valve. If any water, there may
be water drops when opening upper housing. (Since water in steam valve is hot after using,
Steam valve base
maintain after the body is cooled down)
Refer to page 8 for the method of disassembly.
Detachable
Clean inside
Clean up attached foreign matters with bamboo stick
steam valve
inner lid
or toothpick. If not, the sealing ring cannot fall off.
(Otherwise, it will cause deforma-
Cover plate button
Detachable
inner lid
"Please clean it after use"
The top lid cannot be closed if
Temperature sensor of upper
there is no detachable inner lid.
housing
Sealing ring (Removal of
foreign objects)
Insulation base
Inner pot
Outer casing cover
Plug (bottom side)
Opening button seat
Suction port, exhaust port (bottom side)
Suction port and
exhaust port
21
Advertisement
Table of Contents
