Advertisement
3
Connect the BNC from the cover
to the radio port.
Antenna Installation
To install a UHF antenna for the DXi:
1. Insert included rubber grommet into the enclosure hole
for the antenna.
Insert antenna threading through the hole
2. Secure the large nut and antenna connector to threading
2
of antenna
.
3.
Power on the controller and initialize the newly
connected UHF radio board.
Figure 8
(lid x-ray)
Antenna installed on the top of
PSB, SPED, and wallmount enclosures.
4
Reattach the cover and secure
with screws and standoffs if necessary.
1
.
1
2
4. The UHF radio uses the same frequency as the base
radio. Both Rx and TX are on the same frequency.
An FCC or IC license is required to operate the UHF
radio. If the base network is on the internet through an
Ethernet gateway, the "CLOUD ID" will be displayed
on the controller faceplate. Communication at the
Central can be verified by sending test commands via
the Sentinel WMS or Laguna software and looking for
acknowledgment.
Figure 9
Antenna fully contained within plastic pedestal
enclosure when lid is closed.
5
Connect antenna's cable to
BNC connector on cover.
1
2
Advertisement
