Table of Contents
Advertisement
DIVAR IP 7000 (2U)
Rear view:
3.3.1
Control panel buttons
There are two push-buttons located on the front of the chassis. These are (in order from left
to right) a reset button and a power on/off button.
–
–
3.3.2
Control panel LEDs
The control panel located on the front of the chassis has LEDs to provide you with critical
information related to different parts of the system. This section explains what each LED
indicates when illuminated.
Bosch Sicherheitssysteme GmbH
1
2
1
2x power supply modules
3
1x serial port
5
4 USB ports
7
1x VGA display output (do not use!)
9
1x sound card (audio inputs and
outputs)
Reset: The reset button is used to reboot the system.
Power: The main power switch is used to apply or remove power from the power
supply to the system. Turning off system power with this button removes the main power
but keeps standby power supplied to the system. Therefore, you must unplug system
before servicing.
3
4
5
6
2
4
6
8
Installation Manual
System overview | en
7
8
9
2x redundant SSD drives for operating
system (RAID1 mirror)
1x network port for BMC (Baseboard
Management Controller) connection
and IPMI (Intelligent Platform
Management Interface) monitoring
2x network ports for data transmission
(teamed)
Note: Do not change the teaming
mode!
1x graphic card (4x mini display port)
Note: Provides digital signal. An active
adapter is required to connect analog
monitors.
15
2016.08 | V2.1 | DOC
Advertisement
Table of Contents
