Advertisement
Operation
Using the Jack Mount
WARNING
The machine could fall onto someone and
cause serious injury or death.
• Do not keep the machine raised on the jack
for extended periods of time.
• Always use a jack on a level surface.
• Ensure that the jack is secured properly to
the jack mount using a jack pin.
• Do not rely solely on the jack for support.
Use adequate jack stands or equivalent
support.
• Do not mount or dismount the mower while
the jack is raised.
• Before each use, ensure that the jack and
jack mount work properly and that there
are no signs of damage.
Note:
Use only a manufacturer-approved jack rated
at 907 kg (2,000 lb) or higher lift capacity with the
jack mount.
1.
Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Attach the jack to the jack mount with a jack pin
(Figure
2).
1. Jack mount
4.
Use the jack to raise the machine to the desired
height.
Raising the machine could cause a fuel
leak.
• Check for any fuel leaks before
ARK
• If you see a fuel leak, immediately
5.
Support the machine with jack stands; refer to
the machine Operator's Manual for jack stand
placement.
6.
When finished, use the jack to lower the
machine, then remove the jack.
Note:
attached.
2
Figure 2
2. Jack
WARNING
performing maintenance.
lower the machine and drain the fuel
to eliminate the hazard.
Do not operate the machine with the jack
g307429
Advertisement
