Maintenance - Black & Decker BEPW1600LLP Manual

Plug the pressure washer unit into a power source.
u
Actuate the pressure washer by rotating the ON/OFF dial
u
to the ON position .
Turn OFF the pressure washer as soon as water is spray-
u
ing out of the outlet tube of the unit.
Unplug the pressure washer unit from the power source.
u
Assemble the high pressure hose to the high pressure
u
water outlet.
Plug the pressure washer unit into a power source.
u
Actuate the pressure washer by rotating the ON/OFF
u
dial to the ON position.
Actuate the trigger of the spray handle to start clean-
u
ing work.

Maintenance

Warning! To reduce the risk of serious personal injury, turn
unit off and disconnect it from power source before making
any adjustments or removing/installing attachments or acces-
sories. An accidental start-up can cause injury.
Your Black+Decker power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Cleaning
Warning! Blow dirt and dust out of all air vents with clean, dry
air at least once a week.
To minimize the risk of eye injury, always wear approved eye
protection when performing this procedure.
Warning! Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals
may weaken the plastic materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any
liquid get inside the tool; never immerse any part of the tool
into a liquid.
Nozzle Cleaning (Fig. G)
If the nozzle becomes clogged with foreign materials, such as
dirt, excessive pressure may develop. If the nozzle becomes
partially clogged or restricted, the pump pressure will pulsate.
Clean the nozzle immediately using the nozzle cleaner.
Turn OFF and unplug the pressure washer unit ( 16 ).
u
Turn OFF the water supply.
u
Pull trigger ( 7 ) on spray handle ( 4 ) to relieve any
u
water pressure.
Remove the nozzle from the spray wand ( 2 ) by depress-
u
ing the button ( 3 ).
Using the nozzle cleaning tool ( 14 ), unclog any debris
u
from the nozzle.
Run water from a faucet or garden hose through the noz-
u
zle.
Filter Cleaning (Fig. A, L)
Inspect the filter ( 10 ) before each use and clean if neces-
sary. Remove the filter element and run under clear water to
remove any debris.
(Original instructions)
Storage (Fig. H, I)
Store in a dry, covered location above freezing tempera-
u
ture. STORE INDOORS.
Always completely empty water from high pressure hose,
u
pressure washer unit, nozzles, and spray wand.
Nozzles can be stored in the unit as shown in Fig. H.
u
Note: the turbo (BEPW2200) or pen to fan nozzles can be
sotored on the wand.
Power cord can be stored coiled up and secured with the
u
cord retaining hooks ( 21 ) as shown in Fig. I.
High pressure hose ( 1 ) can be stored coiled up and
u
secured to the handle (18) with the help of the hook and
latch strap ( 27 ) as shown in Fig. I.
The spray handle ( 4 ) can be stored onto the rear of the
u
unit using the bracket ( 26 ) as shown in Fig. I.
The spray wand ( 2 ) can be stored onto the rear of the
u
unit using the bracket ( 26 ) as shown in Fig. I.
Accessories
Warning! Since accessories, other than those offered by
BLACK+DECKER, have not been tested with this product,
use of such accessories with this tool could be hazardous. To
reduce risk of injury, use only BLACK+DECKER accessories
recommended for this product.
Recommended accessories for use with your tool are avail-
able at extra cost from your local dealer or authorized service
center. If you need assistance in locating any accessory,
please contact www.blackanddecker.com.
Repairs
Warning! To assure product SAFETY and RELIABILITY, re-
pairs, maintenance and adjustment (including brush inspection
and replacement) should be performed by a Black+Decker
factory service center or a Black+Decker authorized service
center. Always use identical replacement parts
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Protecting the environment
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions.
Service information
BLACK+DECKER offers a full network of company-owned
and authorized service locations throughout Asia. All
BLACK+DECKER Service Centers are staffed with trained
personnel to provide customers with efficient and reliable
ENGLISH
13