Operation - DeWalt DCBL772 Instruction Manual

English
Proper Hand Position (Fig. D)

WARNING:
personal injury, ALWAYS use proper hand position as shown.

WARNING:
personal injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Hold the blower with one hand on the main handle

OPERATION


WARNING:
without blow tube securely in place. Never reach down into
housing through tube hole.

WARNING:
Wear a filter mask if the operation is dusty. Use of rubber
gloves and substantial footwear is recommended when
working outdoors. Keep long hair and loose clothing away
from openings and moving parts.

WARNING:
the tool off, wait 10 seconds for the fan to stop rotating
before removing the blower tube.
• Always ensure the blower is switched OFF and the battery
is removed when:
- You leave blower unattended.
- Clearing a blockage.
- Checking, adjusting, cleaning or working on blower.
• Only use blower in daylight or good artificial light.
Switching ON/OFF (Fig. E)

WARNING:
product firmly when switching on.

CAUTION:
self or bystanders.
• To turn the blower ON, ensure the speed lock lever
the off position and depress the trigger switch
• To lock the blower ON, pull back on the speed lock
lever 2 , as shown in Fig. E. The blower runs at higher
speeds as the lever is moved further. The speed lock lever
can also be pulled back to start the blower without needing
to first depress the trigger switch.
• To turn the blower OFF, release the trigger switch
and/or push forward on the speed lock lever and return it to
its off position.
Use (Fig. C, F)

CAUTION:
self or bystanders.

CAUTION:
and hearing protection. Wear a filter mask if the operation is
dusty. Use of gloves, long pants and substantial footwear is
recommended. Keep long hair and loose clothing away from
openings and moving parts.
• Install the battery pack
• Hold the blow tube approximately 7 inches (180 mm)
above the ground, turn the blower ON and using a
sweeping motion from side to side, advance slowly keeping
6
To reduce the risk of serious
To reduce the risk of serious
Do not operate blower
Always wear safety glasses.
Cut Hazard. When turning
Use both hands to grip the
Do not point unit discharge at
1 .
Do not point unit discharge at
Always wear safety glasses
10 into the battery housing.
the accumulated debris/leaves in front of you as shown in
Fig. F.
MAINTENANCE

WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments or
removing/installing attachments or accessories. An
accidental start-up can cause injury.
.
3
Cleaning

WARNING:
air vents with clean, dry air at least once a week. To minimize
the risk of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.

WARNING:
harsh chemicals for cleaning the non-metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water
and mild soap. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
Accessories

WARNING:
than those offered by D
this product, use of such accessories with this tool could
be hazardous. To reduce the risk of injury, only D
recommended accessories should be used with this product.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D WALT (1-800-433-9258) or visit our website:
e
www.dewalt.com.
Repairs
The charger and batteries are not serviceable. There are no
is in
2
serviceable parts inside the charger or battery pack.

WARNING:
and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a factory service
center or an authorized service center. Always use identical
1
replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will help
you obtain more efficient warranty service in case there is a
problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of an
insurance loss, such as fire, flood or theft, your registration of
ownership will serve as your proof of purchase.
• FOR YOUR sAFETY: Registering your product will allow
us to contact you in the unlikely event a safety notification is
required under the Federal Consumer Safety Act.
Register online at www.dewalt.com/account-login.
To reduce the risk of
Blow dirt and dust out of all
Never use solvents or other
Since accessories, other
WALT, have not been tested with
e
e
WALT Industrial
e
To assure product SAFETY
WALT