Troubleshooting - Makita DVC560PT2 Instruction Manual

TROUBLESHOOTING

Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to disassemble the machine. Instead, ask Makita Authorized Service Centers, always using Makita
replacement parts for repairs.
Symptom
Not working
The brushroll does not rotate
Weak suction power
Loud driving noise
The indicator of excess level of dust blinks
after a little use
LED lamp does not light
The caster wheel is hard to move
Probable cause
Battery cartridges are installed improperly.
The battery cartridges are exhausted.
The handle is installed improperly.
The appliance is locked in upright position.
The indicator of brushroll error is lighting.
The indicator of excess level of dust is
lighting.
If replacing the filter bag does not solve
the problem...
Debris is entangled in the brushroll and the
rotating speed is declined.
The height of brushroll is too high from the floor.
The hair of brushroll has become short.
The appliance is operating in low mode.
The brushroll is not installed.
The pipe or the hose is installed
improperly.
The appliance is operating in high mode.
Debris is entangled in the brushroll.
The filter bag is filled with dust.
If replacing the filter bag does not solve
the problem...
The filter bag is folded.
The LED lamp setting is off.
Debris is entangled in the caster wheel.
17 ENGLISH
Remedy
Install the battery cartridges as described
in this manual.
Charge the battery cartridges.
Install the handle firmly as described in
this manual.
Unlock the upright position of the
appliance.
Inspect that there is no entanglement
around the brushroll (body, cap and joint).
Replace the filter bag.
If the filter bag is not full, unfold the filter
bag and shake it to clear the clogging.
Clean or replace the HEPA filter.
Inspect that there is no debris clogged in
the hose and pipe.
Inspect that there is no entanglement
around the brushroll (body, cap, joint).
Lower the height of the brushroll.
Replace the brushroll.
Lower the height of the brushroll.
Change to the higher operating mode.
Install the brushroll.
Install the pipe or the hose firmly.
Change to the lower operating mode.
Inspect that there is no entanglement
around the brushroll (body, cap and joint).
Replace the filter bag.
Clean or replace the HEPA filter.
Inspect that there is no debris clogged in
the hose and pipe.
Unfold the entrance of the filter bag before
setting it.
During operation, press and hold the
battery check / LED lamp button to turn on
the LED lamp.
Clean the debris on the caster wheel.