Sealey VSE3038 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Wear eye
instructions protection
1. safety
WarninG! ensure Health and safety, local authority and general workshop practice regulations are adhered to when using tool.
‰
maintain tools in good and clean condition for best and safest performance.
9
ensure that a vehicle which has been jacked up is adequately supported with axle stands.
9
Wear approved eye protection. A full range of personal safety equipment is available from your sealey stockist.
9
Wear suitable clothing to avoid snagging. do not wear jewellery and tie back long hair.
9
Account for all tools, locking bolts, pins and parts being used and do not leave them in or near the engine.
9
do not use tools if damaged.
8
imPortant: these instructions are provided as a guide only. Always refer to the vehicle manufacturers service instructions, or a
proprietary manual, to establish the current procedure and data.
2. introduction
crankshaft rear seal remover/installer. time saving tool, supplied with pin punch and self tapping screws to easily remove the old seal. unique
design ensures the new seal is pushed in squarely and correctly. Fits all petrol and diesel 2.25 engines with five bearing crankshaft.
3. sPecification
model no ................................................................. Vse3038
Applications .............................. land rover series iii (80-85)
............................................land rover defender 90 (83-85)
.......................................... land rover defender 110 (83-85)
4. oPeration
4.1. Removing the rear crankshaft oil seal. fig.1.
4.1.1. Ensure the central forcing screw is fitted but does not protrude past the inner face of the body of the VSE3038.
4.1.2. Align the tool on the crankshaft and secure it using the flywheel fixing bolts, hand-tighten only.
4.1.3. using the punch provided, via the holes in the outer perimeter of the tool, strike the punch with a hammer enough to puncture the
seal to provide a pilot hole for the self-tapping screws. Three evenly spaced holes is normally sufficient.
4.1.4. fit a self-tapping screw into each of the pilot holes and tighten them one and a half turns.
note: do not over tighten as this may cause the screws to break.
4.1.5. tighten the central forcing screw hand-tight only and remove
the flywheel fixing bolts used to secure the VSE3038 to the
crankshaft.
4.1.6. tighten the central forcing screw to remove the oil seal from its
housing.
4.1.7. remove the self-tapping screws and discard the oil seal.
© Jack sealey limited
instructions for
rear main oil seal remover/installer -
land rover 2.25
model no:
Wear protective Wear safety
gloves footwear
Original Language Version
vse3038
Wear protective
clothing
fig.1
Vse3038 | issue 1 19/01/17