Mitsubishi Electric PAC-USSEN001-FM-1 Installation Instructions Manual

MANUFACTURED FOR:
MITSUBISHI ELECTRIC US, INC.
Flush Mount Room Temperature Sensor
PAC-USSEN001-FM-1
INSTALLATION/INSTRUCTION MANUAL
For your safety, first be sure to read 1.Safety Instructions and then
install the Flush Mount Room Temperature Sensor
PAC-USSEN001-FM-1 correctly.
Contents
1. Safety Instructions
2. Confirming the Supplied Parts
3. Mounting Instructions
4. Troubleshooting
5. Setting Indoor Units
6. Thermistor Calibration Table
1. Safety Precautions
1. Safety Instructions
This sensor is not polarity sensitive and includes 24" of 22/2 AWG (ETFE) stranded etched Teflon wires for
making all of the proper connections. Mitsubishi Electric recommends using 22/2 AWG UL 1007 non-
shielded wire for up to 100' with this application. Temperature measurement range: 41° to +140˚ F (5° to
+60˚ C)
• The following two symbols are used to denote dangers that may be caused by incorrect use and their
degree:
This symbol denotes what could lead to serious injury or death if your misuse the PAC-USSEN001-FM-1.
WARNING
This symbol denotes what could lead to a personal injury or damage to your property if you misuse the PAC-USSEN001-FM-1.
CAUTION
• After reading this installation manual, keep it in a place where the final user can see it anytime he or she
wants to.
When someone moves, repairs or uses the PAC-USSEN001-FM-1, make sure that this manual is
forwarded to the final user.
Ask your dealer or technical representative to
install the unit.
Any deficiency caused by your installation may
result in an electric shock or fire.
Install In a place which is strong enough to
withstand the weight of the PAC-USSEN001-
FM-1.
2. Confirming the Supplied Parts
Any lack of strength may cause the PAC-
USSEN001-FM-1 to fall down, resulting in
2. Confirming the Supplied Parts
personal injury.
Confirm that following parts are enclosed in the box in addition to this Installation Manual
Firmly connect the wiring using the specified
• Flush Mount Sensor cables. Carefully check that the cables do not
exert any force on the terminals.
• Threaded Insert
Improper wiring connections may produce heat
• Noise Filter Board with CN20 Connector
and possibly a fire.
• Conversion cable
• Instruction Sheet
Never modify or repair the PAC-USSEN001-
FM-1 by yourself.
Any deficiency caused by your modification or
repair may result in an electric shock or fire.
Consult with your dealer about repairs.
Specifications are subject to change without notice.
FOR INSTALLER
WARNING
Ensure that installation work is done
correctly following this installation manual.
Any deficiency caused by installation may result
in an electric shock or fire.
PAC-USSEN001-FM-1
All electrical work roost be performed by a
licensed technician, according to local
regulations and the Instructions given In this
manual.
Any lack of electric circuit or any deficiency
caused by installation may result in an electric
shock or fire.
Do not move and re-Install the PAC-
USSEN001-FM-1 yourself.
Any deficiency caused by installation may result
in an electric shock or fire.
Ask your distributor or special vendor for moving
and installation.
Do not turn on the main power until
installation has been completed.
Fail to do so may cause an electric shock or fire.
5 © 2018 Mitsubishi Electric US, Inc.
7 © 2018 Mitsubishi Electric US, Inc.
i
3. Mounting Instructions
must
i i
i
do
,
a place with much
steam s
i
© 2021 Mitsubishi Electric US, Inc.