Punch Fape (Optional) - GE TermiNet 300 Operator's Manual

GEH-2184A Operator's Manual
ROD
PLATEN
I
/
/
PA PER FORWARD
--"\--t_---i
FEED DIRECTION
5
11
PAPER
ROLL
PRESS HERE TO RELEASE
PAPER OUT SWITCH IF IN LOCKED POSITION
PRESS DOWN HERE TO
"LOCK OUT
11
PAPER SWITCH
--
-
-
---
-
-
-
-
----
-
-
- -
- .....
\
\
)
--
\
~//----;
PAPER OUT
I
,,~
\
\
SWITCH (EMPTY / PAPER OUT SWITCH
ROLL POS)
/~+t-'
(FULL ROLL POS)
LOCKED POS)
---
CD
PAPER OUT SWITCH IN LOCKED POSITION -DEFEATS ALARM - ENABLES OPERATIO·N
@PAPER OUT SWITCH IN FULL ROLL RANGE - ENABLES OPERATION
@
PA PER 0 UT SWITCH IN LOW PAPER POSITION
Fig. 6. Paper installation diagram
Installation 1. The paper release lever must be in the re-
Follow the steps listed below in order.
1. Press the cover release latches and raise the
cover.
2. Place the tube in the center of the roll.
3. Set the roll in place.
4.
Feed the paper from the bottom of the roll
over the dancer bar and under the platen.
5. Push the platen knob in, and rotate to advance
the paper.
6. To align the paper, release the paper friction
lever and align the left edge of the paper with the
red line on the shield.
7. Return the paper release lever to the engaged
position.
8. When using sheet or pin feed paper, depress
and lock the paper-out lever.
Pin-feed Paper (Optional)
Follow the additional steps listed below for the
installation of pin-feed paper.
6
leased position.
2. Lock the paper-out lever.
3. Insert the paper and align paper holes with the
sprocket pins.
4. Advance the paper with the platen knob.
NOTE: Paper release lever
;nus t be !e_ft in the
release position (forward) while
using· a
pin feed
platen.
PUNCH TAPE (OPTIONAL)
Inserting Punch Tape
1. Place a roll of 1-inch wide tape on the supply
spool (see Fig. 7).
2. Feed the tape around the guide rolls
(2)
~111d
through the angle arm.
3. Move the tape guide arn1 forward.
PLu·<· !
IH'
tape under the hold down, leavinµ; enou~h <'~t·c·~~~
tape to fit through the opening in the
front ()f ! IH·
drawer.