C Vertical Steam; Auto Shut Off; Ironing Without Steam - Siemens TS2231100 Operating Instructions Manual

4. The "steam ready" indicator lamp (9) will light
up after several minutes, indicating that steam
is ready to be released.
5. Press the steam release button (15-16*) to
release steam.
Tips:
• Sort your garments out based on their
cleaning symbol labels, always starting with
clothes that have to be ironed at the lowest
temperatures.
• If you are not sure what the garment is made
of then begin ironing at a low temperature and
decide on the correct temperature by ironing a
small section not usually seen when worn
• At the beginning of each use, it is possible that
drops of water will be dispensed alongside
steam.
Therefore, it is advisable to try the iron on the
ironing board or a piece of cloth to start with.
"pulseSteam"
function
This appliance has a special function for tackling
difficult creases.
The "pulseSteam" function helps soften
stubborn garments like jeans or linen faster.
When the steam release button is activated, the
steam generator will release three powerful
shots of steam so that the steam reaches even
deeper into the fabrics.
1. Set the setting selector (10) on "• ••"
2. Briefly press the steam shot button (16*) on
the top of the handle.
or (model dependent)
Press the steam release button (15) on the
bottom of the handle two times in quick
succession (double-click).
Remarks:
• It is possible to stop the shots of steam by
quickly pressing the steam button again.
• Some water drops may appear when you use
the "pulseSteam" function for the first time.
The water drops will disappear after you have
used the function for some time.

Ironing without steam

Begin ironing but without pressing the steam
release button.
C
Vertical steam
This can be used to remove creases from
hanging clothes, curtains etc.
Warning!:
E
Never direct the steam jet at garments
that are being worn.
Never aim the steam at people or
animals.
1. Set the temperature to the "•••" setting.
2. Hold the iron in an upright position 15 cm away
from the garment being steamed.
3. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing
the iron in a vertical position and pressing the
steam release button (15 or 16*).
"intelligentSteam" function
(Model dependent)
This system has intelligent steam control, which,
after releasing the steam release button (15),
provides a small amount of additional steam.
The additional steam can always be stopped by
briefly pressing the steam release button once
again.
"silencePlus" mode
Push the "silencePlus" button (8).
If the "silencePlus" mode is activated, you can
reduce the steaming noise for more than 50%
(*), and still achieve good results when ironing
most of your garments.
It is advisable to use the normal setting only for
thick and very wrinkled fabrics.
(*) In comparison to the maximum setting.
Auto shut-off
(Model dependent)
If during ironing, the steam release button
(15-16*) on the iron handle is not pressed for a
certain length of time (8 minutes), the steam
station will automatically switch off.
The "auto shut-off" pilot lamp (9) will flash when
auto shut-off has been activated (three beeps
may be heard).
To switch the steam station back on, press the
steam release button again.
17
SIEM ENS