Table of Contents
Advertisement
Clock Set Button:
Clock Set CE
When oven is first plugged in, display window will show the colon blinking.
in —S,
To set clock:
Step 1. Enter time of day by touching appropriate Time Select Pads.
Example:
To set 11:25 (a.m. or p.m.), touch Time Select Pads as follows:
twice
To right
5 times
—Time appears in display window; colon is blinking.
Step 2. Push Clock Set Button.
—cColon stops blinking; time of day is entered and locked into display.
Note:
1) Clock must be set before oven will operate.
2) To reset time of day in display window, push on Clock Set Button to clear the
time. Colon will begin to blink. Enter the correct time of day by following the
above procedures.
MN
eG
SEC
Time Select Pads:
1——»
1) Used for MICROWAVE (Except LOW Power):
ey
The Pads serve as a 10 minute pad, 1 minute pad,
10 second pad and 1 second pad
from the left.
Se
Il] is
a
(Example 1: To set 13 minutes 45 seconds)
Touch:
1 HOUR
""H"
10MIN
Pad:
once
|
uy o
MIN
1 MIN Pad: 3 times
io
10SEC
Pad: 4 times
1 SEC
Pad: 5times
(Example 2: To set 30 seconds)
J9)
Touch:
_
LJ
10SEC
Pad:
3times
2) Used for CONVECTION, COMBINATION, Delay /Stand and LOW Power:
The Pads serve as a 1 hour pad, an inoperable pad, 10 minute pad and 1 minute pad
from the left.
(Example 1: To set 2 hours 25 minutes)
Touch;
1 HOUR
Pad: twice
10MIN
Pad: twice
1 MIN 'Pad: 5 times
1 MIN Pad: 5 times
Note: When Convection, Combination, Delay/Stand or LOW power is selected, the
seconds will not visibly count down in the display window until only 59 minutes
remain. The timer will then display minutes and seconds, and seconds will visibly
count down.
Advertisement
Table of Contents
