Pioneer A-88X Operating Instructions Manual

Operating
Instructions
Side panels not supplied with
Europe and U.K. Models.
STEREO AMPLIFIER
A-88X
Photograph shows BLACK finished model.
Thank you for buying this Pioneer product.
Please read through these operating instructions and then you
will know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In accordance with the power and voltage requirements of dif-
fering areas, the following model names are used to designate
models with differing electrical specifications.
Line voltage
HE, HEZ,
NE, NEZ
WE, WB, WP} a.c. 220—240 volts ~
S, $/G, SS AC 110, 120, 220, 240 volts (Switchable voltage)
D, D/G AC 120, 220, 240 volts (Switchable voltage)
R, R/G AC 110—120, 220—240 voits (Switchable voltage)
KU, KC AC 120 volts
YP, YB
HB, HP
a.c. 220 volts ~
a.c. 240 volts ~
NOTES:
e The model names are stamped on the packing case.
¢ These operating instructions are prepared on the basis of the KU
model, and they can be used for other models. Although the
design of the power plug and the power outlet shown may differ
from the actual one, the operating procedures are the same.
WARNING: To prevent FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CONTENTS
Specifications ....... Disa wiGn tienen mera teanl Mean Meds
TFOUDIESNOGTING ccccccsccc cnc csecasedeei scene dee aere eas
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S.A., Canadian, European, U.K., and
Australian models are not provided with this switch.
You will find the line voltage selector switch on the rear panel.
This switch has positions for 110 V, 120 V, 220 V and 240 V
power sources. Before your model is shipped from the fac-
tory, the switch is set to the power requirements of the
destination; nevertheless, you should check that it is set pro-
perly before plugging the power cord into the AC outlet. If the
voltage is not properly set or if you move to an area where the
voltage requirements differ, adjust the selector switch as
follows. Before adjusting disconnect the power cord.
1. Provide yourself with a medium size flat tip screwdriver.
2. Insert the screwdriver into the arrow on the voltage selec-
tor and adjust so that the tip of the arrow points to the
voltage value of your area.
VOLTAGE SELECTOR
Medium size screwdriver
120V 240V
IMPORTANT NOTICE [For U.S.A. and
Canadian models]
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
ranty card and keep in a secure area. This is for your security.