Advertisement
IMPORTANT 1
The lightnirig' flash With arrowhead, within'an'equi-
lateral wiengle, is intended to alert the user of the
presence of uninsulated "dangerous voltage" within
the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to
persons.
IMPORTANT 2
If the apparatus is fitted with AC mains power out-
let(s), see REAR PANEL FACILITIES for convenient
connection of additional Hi-Fi component(s). Make
all connections to the AC outlet(s) and the signal
terminals first. Connect the plug to the wail socket
last, make sure that the power switch is off.
READ
INSTRUCTIONS—All
the
safety
and
Operating instructions should be read before the
appliance is operated.
RETAIN INSTRUCTIONS — The operating instruc-
tions shouldbe retained for futtire refererice.
HEED WARNING — All warnings on the appliarice
and: in the: operating'
ingtrictions" should
be
adhered to.
FOLLOW INSTRUCTIONS ~ Alll oparating and use
instructions should be followed.
WATER. AND, MOISTURE.— The appliance should
not be used near water — for example, néar's
bathtub, washbowl, kitchen sink, laundry tub; ira
wet basement, or near 8 swimming pool, etc.
LOCATION.The appliance should be installed.in 2:
stabie location,
:
WALL OR: CEILING' MOUNTING — The appliance
should not be. mounted to, a: wall of ceiling.
VENTILATION — The appliance should be situated
§0/that its! location or: positiGn' does 'not interfere:
with its. proper. ventilation. For. example, the. ap-
pliance stould not be situated on a bed, sofa, tug,
or, similar:surface: that, may:block: the: ventilation:
openings; or, placed in a built-in installation, such
"'as'4' bookcase oF cabinet that may impede the
flow of air through the ventilation openings.
HEAT — The appliance should be situated away from
heat sources such as radiators," heat' registers,
stoves, of other appliances (including amplifiers)
that produce heat:
POWER:
SOURCES. The. appliance
should - be
connected to a power supply only. of the. type
described
in the operating
instructions
or as
marked on the appliance,
POWER-CORD
PROTECTION — Power-supply
cords should be routed so that they are-not likely
to be walked on or pinched by items placed upon
of against them, paying particular attention' to
cords at plugs, convenience receptacles, and the
point where they exit fromthe appliance.
POLARIZATION
— If your
purchased:
product
is,
'CAUTION:
o f
TO PREVENT THE RISK OF ELECTRIC SHOCK,
DO
NOT
REMOVE
COVER
{OR
BACK}.
NO
USER-SERVICEABLE
PARTS
INSIDE.
REFER
SERVICING
To
QUALIFIED
SERVICE
PERSONNEL.
FOR USE IN THE UNITED
KINGDOM
WARNING: This plug must only be connected
to electronic apparatus equipped with suitable
sockets.
If not, cut off the plug and fit an appropriate
type
in
accordance
with
the
instructions
below.
'The cut-off. plug. must, be. disposed: of as. an
electrical shock hazard could exist if connected
'to'a socket outlet.
POWER
LINES
— An outdoor antenna should be
located away from power lines.
NONUSE
PERIODS—The
power
cord
of the
appliance should be unplugged from the outlet
'wher left unused for a long period of time.
OBJECT AND LIQUID
ENTRY —Caré should be
taken''so that objects do not fall 'and liquids: are'
not:spilied into the enclosure through openings.
DAMAGE REQUIRING SERVICE — The appliance
should be' serviced by a Pioneer authorized ser-
vice center or qualified service personnel when:
®
Objects have fallen, or liquid has been spified into
the appliance: or
i
The appliance has been exposed to rain;.or.
The appliance does not appear to operate nor-
mally. or exhibits a marked change' in pertor-
mance; or
@:°:
The appliance has been dropped; or the enclosure
damaged.
SERVICING —The
user
should
not
attempt
to
Service the appliance beyond that described in the
operating instructions. For: ali other servicing,
'contact thé nearest
Pioneer authorized: service
center.
POWER LINES.
SERVICE
ENTRANCE
CONDUCTORS,
*
The exclamation point within an equilateral triangle is
intended to alert the user of the presenée of important
operating and maintenance (Seivicing) instructions in
the literature accompanying the appliance.
The wifes in this mains lead are coloured in accor-
dance with the following code:
Blue
Neutral
:
Brown:
Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
marking identifying the terminals in your plug proceed
as follows:
i
The'wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black
The.wire which
is coloured browa' must be connected
to the terminal which is marked with the letter L or
colotifed red.
"
OUTDOOR ANTENNA GROUNDING — ff an out-
side antenna is connected to the antenna termi-
nal; be sure the antenna system is grounded so.as:
to provide some protection against voltage surges.
and, built up, static: charges:
sear
In the U.S.A; section' 810 of the National Elec-
twical.Code, ANSI/NFPA 'No. 70-1984, provides:
information with respect to proper grounding, of
the mast and supportirig structure, grounding of
the lead-in wire to'@nv antenna discharge
unit: size
of grounding Conductors, location of antenna:
discharge. unit;. connection. to..grounding® ales,
trodes, and requirements for the grounding elec-
trode. See Fig. A.
a) Use No. 10 AWG (5.3 mm?) cop:
per, Now 8 AWG (8.4 mm?) alu-
minum, No. 17 AWG MO mm?)
copperciad steel, bronze wire, or
larget-as ground: wire.
b).
Secure.
antenna
lead-in
and:
"ground 'wires to house with
stand-off insulators: spaced from
4 feet (4,22:.meters)
to: 6: feet
(1:83 meters). apart:
¢)...
Mount-antenna discharge unit 'as
closely as possible to where iead-
in' enters house.
STAND-OFF.. . .
d):.. Use. jumper-wire:not smaller than:
INSUEATORS ©
No.6 AWG" (13.3 mm?) copper,
'oF the equivelent, when a sepa-
sate antenna-grounding electrode:
is used.
i
See NEC Section 810-21
{j).
provided with a polarized power plug. please read
the following instructions. This product is
"
equipped with a polatized alternating current line
plug (2 plug having one blade wider than the
'ather), This plug will firinta the power outlet only
ca
one way, This is a safety feature, If you are unable
to insert the plug fully into the outlet, ty reversing
the plug. If the plug should still fail to fit. contact
your electrician to replace your obsolete outlet.
Do not defeat the safety purpose of the polarized
8
plug
POWER SERVICE
CLEANING — The appliance should be cleaned only
GROUNDING ELECTRODE SYSTEM
with a polishing cloth or a soft dry cloth. Never _ (8. interior metal water pipe)
clean with furniture wax, benzine, insecticides or
ANTENNA
LEAD-IN WIRE
TO EXTERNAL ANTENNA
TERMINALS OF PRODUCT
1, GROUND
WIREab
6
gi LAMPS
>
4
ANTENNA
DISCHARGE UNIT ¢
GROUND
WIRE ab
SERVICE ENTRANCE
EQUIPMENT:
GROUNDING ELECTRODE
DRIVEN 8.FEET (2.44 m)
&
Advertisement
