Sealey ADB100T Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instruction gloves
manual
1. SAFETY
WARNING: ADB100T must ONLY be used for AdBlue®.
‰
Place the tank on a flat surface before filling.
9
Secure the tank to strong points with ratchet straps before transporting in or on a vehicle.
9
Maintain the pump in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use recommended parts only. Non authorised parts may be dangerous and will invalidate the warranty.
9
Keep the pump clean for best and safest performance.
9
Ensure the power supply (vehicle battery) corresponds with the requirements of the pump (12V DC).
9
Disconnect from battery when not in use.
9
Wear protective gloves, and protective clothing when working around liquids. A full range of personal safety equipment is available from
9
your local Sealey stockist.
Keep children and unauthorised persons away from the working area.
9
DO NOT place the tank near any heat source.
8
DO NOT start or stop the pump by connecting or disconnecting the battery clamps.
8
DO NOT allow the unit to get wet.
8
DO NOT operate the pump with wet hands.
8
DO NOT use the pump where explosive or flammable vapours may be present.
8
DO NOT tamper with the pump connections.
8
2. INTRODUCTION
i
Manufactured from HDPE for the safe transportation and dispensing of Adblue® when supplying on site equipment. Supplied with a 12V
electric pump, 4mtr electric cable and clamps, and a 4mtr delivery hose and fuel nozzle. Can be safely secured and transported on an
ATV, pick-up truck or van using moulded grooves for tie-down straps and handles for positioning. Not suitable for petrol or diesel.
3. SPECIFICATION
i
Model ..................................................................... ADB100T
Capacity ........................................................................ 100ltr
Flow rate .................................................................. 20ltr/min
Power ............................................................................180W
Voltage .............................................................................12V
Current .............................................................................15A
Size (W x D x H) .....................................900 x 500 x 480mm
Nett weight .................................................................. 12.5kg
Duty cycle ............................................ 30mins on/30mins off
© Jack Sealey Limited
PORTABLE ADBLUE TANK 12V - 100LTR
MODEL NO:
Wear eye Wear protective
protection clothing
Original Language Version
ADB100T
ADB100T Issue 1 28/11/18