Advertisement
BATTERY
PACK/CHARGER
The battery pack and charger are not included with
your worklight. They are both sold separately. When
purchasing, use the following information:
MODEL NO,
BATTERY PACK
CHARGER
973,113900
Item No. 9_ 11378
Item No. 9_ 11379
(1323509)
(1426101 )
BATTERY
PACK
The battery pack for your worklight has been shipped
in a low charge condition to prevent possible prob-
lems. Therefore, you should charge it overnight prior
tO use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (operating
worklight followed by recharging) for batteries to
become fully charged.
CHARGING
BATTERY
PACK
See Figure 1.
•
Charge battery pack only with the recommended
charger.
•
Make sure power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
•
Connect charger to power supply.
•
Place battery pack in charging stand. Align raised
rib on battery pack with groove in charging stand.
See Figure 1.
•
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in
charging stand.
•
The charge indicator light (LED), located on the
charging stand, will light up red and glow when the
charger is properly connected to power supply.
This light indicates the charger is operating
properly. It will remain on until battery pack is
BATTERY PACKSHOWN
IN CHARGING STAND
removed from charging stand or charger is discon-
nected from power supply.
•
Note: If charger does not charge battery pack,
return battery pack and charger to your nearest
Sears Repair Center for electrical check.
•
After normal usage, 3 hours or less of charging
time is required to fully recharge battery pack.
Note: If battery pack is completely discharged, 6
hours or longer of charging time is required to fully
recharge battery pack.
•
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
•
Do not place charger in an area of extreme heat
or cold. It will work best at normal room tempera-
ture.
•
When batteries become fully charged, unplug
charger from power supply and remove the battery
pack.
IMPORTANT
INFORMATION
FOR RECHARG-
ING HOT BATTERIES
When using your worklight continuously,
the batteries
in your battery pack will become hot. You should let a
hot battery pack cool down for approximately 30
minutes before attempting to recharge.
Note: This situation only occurs when continuous use
of your worklight causes the batteries to become hot.
It does not occur under normal circumstances.
Refer
to "CHARGING
BATTERY PACK" for normal re-
charging of batteries. If the charger does not charge
your battery pack under normal circumstances,
return
both the battery pack and charger to your nearest
Sears Repair Center for electrical check.
CHARGER
RED LIGHT
(LED)
CHARGING STAND
Fig. 1
Advertisement
