Panasonic AJ-MC900G Operating Instructions Manual page 5

EMC NOTICE FOR THE PURCHASER/
USER OF THE APPARATUS
1. Pre-requisite conditions to achieving compliance with the
above standards
<1> Peripheral equipment to be connected to the
apparatus and special connecting cables
• The purchaser/user is urged to use only equipment
which has been recommended by us as peripheral
equipment to be connected to the apparatus.
• The purchaser/user is urged to use only the connecting
cables described below.
<2> For the connecting cables, use shielded cables
which suit the intended purpose of the apparatus.
• Video signal connecting cables
Use double shielded coaxial cables, which are
designed for 75-ohm type high-frequency applications,
for SDI/SDTI (Serial Digital Interface).
Coaxial cables, which are designed for 75-ohm type
high-frequency applications, are recommended for
analog video signals.
• Audio signal connecting cables
If your apparatus supports AES/EBU serial digital audio
signals, use cables designed for AES/EBU.
Use shielded cables, which provide quality performance
for high-frequency transmission applications, for analog
audio signals.
• Other connecting cables
Use double shielded cables, which provide quality
performance for high-frequency applications, as
connecting cables.
2. Performance level
The performance level of the apparatus is equivalent to or
better than the performance level required by these standards.
However, the apparatus may be adversely affected by
interference if it is being used in an EMC environment,
such as an area where strong electromagnetic fields are
generated (by the presence of signal transmission towers,
cellular phones, etc.). In order to minimize the adverse effects
of the interference on the apparatus in cases like this, it is
recommended that the following steps be taken with the
apparatus being affected and with its operating environment:
1. Place the apparatus at a distance from the source of
the interference.
2. Change the direction of the apparatus.
3. Change the connection method used for the
apparatus.
4. Connect the apparatus to another power outlet where
the power is not shared by any other appliances.
E-2