Advertisement
3.
Remove the 2 bolts and washers that secure the
controller cover for the power center to the relay
mount, and remove the cover
Figure 2
1. Controller cover
2. Washer
4.
Remove the 2 bolts and nuts on the side of the
controller housing
5.
Secure the mounting bracket to the machine
using the previously removed bolts and nuts
(Figure
3).
Figure 3
1. Existing bolts
(Figure
2).
3. Bolt
(Figure 3
and
Figure
4).
2. Mounting bracket and
sensor
Routing the Wire Harness
1.
Plug the 90° connector into the bottom of the
sensor module
g211643
1. 90° connector
2.
Route the wire harness back and plug into the
connector labeled Telematics on the machine
wire harness
3.
Secure the harness to the machine.
g317367
3
(Figure
4).
Figure 4
2. Main harness connector
(labeled Telematics)
(Figure
4).
g317506
Advertisement
