Sealey STS01 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
Ensure the folding step is in good order and condition.

Apply vehicle handbrake and chock wheels before attaching or using the wheel step (put automatics in 'Park').

Ensure that the vehicle is stable before using the wheel step.

Ensure that the wheel step is mounted level on the wheel/tyre.

DO NOT use if damaged.

DO NOT heavily load the vehicle causing the suspension to depress whilst the wheel step is in place.

WARNING! The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations that

may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. INTRODUCTION
Heavy-duty wheel step gives safe and easy-access to engine or top of vehicle, ideal for 4x4s. Heavy gauge all steel construction folds for
easy storage. Suitable for wheel diameters between 14" and 20" and will fit tyres up to 10" deep. Rubber topped platform for added grip
and safety. Platform is height-adjustable (three mounting points 90mm apart).
3. SPECIFICATION
Model No: ............................................................ STS01
Maximum Capacity: ............................................... 225kg
Platform Size:.............................................210 x 560mm
Wheel Diameter: ................................................. 14"-20"
4. OPERATION
WARNING! To prevent personal accident and/or damage to the vehicle, it is imperative that the vehicle does not move during the fi tting

or use of the wheel step. Chock the wheels and ensure that the vehicle handbrake is on. Put automatics in 'park'.
4.1. Unfold the step frame. Take the step in its fl at condition as shown in fi g.1 and pull the adjustable wheel bar (C) into position.
4.1.1. Using bar (C), lift the whole frame away from the step into the fully open confi guration shown in fi g.2.
FIG.1
4.2. Adjust bar (C) to suit tyre depth (A): Bar (C) can be set to one of three positions as indicated at 4, 5 & 6 in fi g.2. These holes occur on
both sides of the frame. To move the bar to the next set of holes, depress the sprung chrome buttons (7) on either side into the frame
and slide the frame in or out until the buttons 'pop out' into the next set of holes.
4.3. Adjust height of step (B): There are three positions for the step as indicated at 1, 2, & 3 in fi g.2. Loosen and remove nut (8) on both
sides of the step. Withdraw the two bolts and reassemble the step at the height required ensuring that the nuts are not so tight as to
prevent the hinges operating when it is required to fold the frame fl at. The step height can be changed either before or after hanging the
frame onto a vehicle wheel/tyre.
4.4. Hang frame on tyre: Ensure that the handbrake is on and the wheels are chocked before positioning the wheel step.
© Jack Sealey Limited
FOLDING WHEEL STEP
STS01
MODEL NO:
Original Language Version
FIG.2
STS01 Issue 2 (H,F) 14/08/23