Table of Contents
Advertisement
1. Check if the TV turns on with the remote control.
Point the remote control at the sensor on the front of the TV and press the power button on the
remote control.
Check if the TV turns on.
If the TV does not turn on, try resetting (restarting) the TV.
If a full reset (restart) of the TV is required
2. Check if the TV turns on with the power button on the TV.
Press the power button on the TV and check if the TV turns on.
For the location of the power button, refer to the Reference Guide/Setup Guide.
If the TV turns on with this procedure, there may be a problem with the remote control. Refer
to the following topic.
The remote control does not operate.
3. Unplug the AC power cord (mains lead).
Unplug the TV power cord (mains lead) from the electrical outlet. Then press the power button
on the TV and wait for 2 minutes, and plug the power cord (mains lead) back into the
electrical outlet.
Hint
When you unplug the TV and plug it in again, the TV may not be able to turn on for a
while, even if you press the power button on the remote control or TV. This is because it
takes time to initialize the system. Wait for about 10 to 20 seconds, then try again.
Related topics
The remote control does not operate.
If a full reset (restart) of the TV is required
[136] Troubleshooting
Connected devices
No picture from a connected device.
You cannot select a connected device.
You cannot find a connected BRAVIA Sync HDMI device.
You cannot turn off the cable/satellite box using the TV's remote control.
Advertisement
Table of Contents
