LG F-C12085V2B Owner's Manual page 15

NOTE
• Before connecting the inlet hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, and etc.) in the
water lines. Let the water drain into a bucket,
and check the water temperature.
Connecting Screw-Type Hose to Tap
Without Thread
1
Loose the four fixing screws.
Upper Upper
connector connector
Fixing screw Fixing screw
2
Remove the guide plate if the tap is too large to
fit the adapter.
Guide plate Guide plate
3
Push the adapter onto the end of the tap so that
the rubber seal forms a watertight connection.
Tighten the four fixing screws.
4
Push the supply hose vertically upwards so
that the rubber seal within the hose can adhere
completely to the tap and then tighten it by
screwing it to the right.
Rubber Rubber
seal seal
Connecting One Touch Type Hose
to Tap Without Thread
1
Unscrew the adapter ring plate and loose the
four fixing screws.
2
Remove the guide plate if the tap is too large to
fit the adapter.
3
Push the adapter onto the end of the tap so that
the rubber seal forms a watertight connection.
Tighten the four fixing screws and the adapter
ring plate.
Plate Plate
Supply Supply
hose hose
Ring plate Ring plate
Guide plate Guide plate
EN
15