Advertisement
1-5-4.
Upper Drum Removal
Serial No.
(200,001 to 218,000)
(200,001 to 203,000)
As illustrated below, in the case that the cap screws are romoved to
adjust the cylindrical
degree and to replace RD for maintenance
service, Remove
tham
by the L wrench
(Subtense
3 mm)
after
removing the ASS'Y of the slack detecting unit.
It is due to the reason why the cap screw can not be turned so that
the L wrench may touch to the shaft portion of the slack detecting
arm (B)
@
Remove
@ PSW 3x6, and take up it from the pinchfitting lever shaft
Slack detecting
ARM (8)
Remove
the pulling coil spring
from the pinch fitting lever pin
Shaft portion
Slack detecting unit ASS'Y
Pinch fitting lever pin
Pinch fitting lever shaft
Cap screws
a
L wrench
(subtense 3 mm]
The cap screw of this side can not be turned
1-9
Advertisement
