Makita HK1820 Technical Information page 15

W
iring diagram
[2] Wiring in Handle Base and Handle
Low Voltage Areas where Radio Interference Suppression Is Required
Fig. D-4B
Put the slack portion of
Grounding wire in this space.
Grounding wire (clear)
Fix Grounding wire (clear)
with this Lead wire holder.
Controller
Route all of the Controller's
Lead wires and grounding
wire (clear) through this slit.
Fix the following Lead wires of
Controller with this Lead wire holder:
*Grounding wire (clear)
*Lead wires (black, red) to Connector
housing A
Fig. D-5B
Fix all of the Lead wires to Switch
with this Lead wire holder of
Switch holder complete.
Route all of the Lead wires
to Switch through between
the boss and the rib.
Pass the following Lead wires
through this hole:
*Noise suppressor's Lead
wires (black)
*Controller's Lead wires covered
with Polyolefin tube (black)
*Lead wire (red) from
Connector housing A
*Controller's Lead wire (white)
Put the slack portion of
Lead wires in this space.
Handle base,
viewed from Controller side
Controller
Get other manuals https://www.bkmanuals.com
Fix Grounding wire (clear)
with this Lead wire holder.
Terminal of Grounding wire
Lead wires covered with
Polyolefin tube (black)
red
white
Pass these Lead wires from Controller
and Connector housing A through
the hole illustrated to right in Fig. D-2.
Connector housing A
The Lead wires to Connector
housing A must be tight between
Controller and Lead wire holder.
Handle, viewed from Handle cover side
Switch holder
Switch
Pass Controller's Lead wires covered
with Polyolefin tube (black) between
Switch and Switch holder's wall.
rib
Handle Base,
boss
viewed from Handle side
Pass Grounding wire (clear)
through the hole illustrated
to right in Fig. D-2.
Grounding wire (clear)
Noise suppressor
P 15/17