Table of Contents
Advertisement
2nd Display
1. Remover the top peripheral mounting hole cover from the device and pull out
the connector from the device.
2. Adjust the hinge of the custom monitor (2nd display), and then connect to the
device as shown below.
NOTE: 2nd display cable need remove the connector cover first.
3. Mount the customer display to the device and tighten the two PHILLIPS M3
screws as shown below.
4. Please install 2nd display USB driver after device installation.
Please visit product web site and get driver:
http://service.ebn.com.tw/tgcs
9
Advertisement
Table of Contents
