Table of Contents
Advertisement
13.3.6 Press [6] for Output Test
When you press [6] for Output test, the display shows Output 1, Hold [*] for ON. Press and hold the [*]
key to turn output on. Press the [*] key (without holding) to end current output test and to advance to next output.
Press [Cmd] to return to the Installer's Menu.
13.3.7 Press [7] for RF Menu
Pressing [7] moves the system into the RF Menu. This menu consists of three scrolling choices that allow you to
add RF ID codes, test RF devices and view or remove RF ID codes.
13.3.7.1 Adding RF ID Codes
To add RF ID codes into the system, press [1] when "Add RF ID? Press 1." scrolls across the display. The
display will then show the following:
To add the location shown in Figure 46 as an RF device to the system (Location 9 used as an example), press
[9] followed by [*]. The following display will then be shown:
Enter the 9-digit ID code found on the back of the RF device and then press [Cmd]. "ID added. Press Cmd." will
appear on the second line of the display, indicating that the code has been successfully entered and accepted.
Press [Cmd].
If an error message appears, make sure you enter the code as printed on the back of the device and that you
only enter nine digits.
Press [Cmd]. The display returns to the first location designated as an RF device and scrolls through other RF
device locations (if any). You may enter the desired location number and add the ID code as described above.
When all RF ID codes have been entered, press [Cmd] once. The first line of the display will show "Configuring
RF Please Wait." During this period, the RF Receiver's LED will blink approximately once every second until all
ID bytes have been recognized. If the devices are successfully configured, the display will return to the scrolling
RF Menu.
If an error message appears, make sure the RF Receiver's transmit lines are properly connected to the D6412/
D4412 and that no shorted conditions are present.
From the RF Menu, you may choose 1 to enter additional RF ID codes or you may select one of the other RF
Menu choices. If you are finished with the RF Menu, press [Cmd] to return to the main programming menu.
• Locations 41-44: RF Keypads (4 max – 1 per Location)
• Locations 45-76: RF Keyfobs
© 2002 Radionics
Installer's Keypad & Installer Mode
Location Area
Loc9
A1
To add push 9*.
Key sequence to press
Figure 46: Adding RF ID Codes Menu Display
Enter ID for
Loc9
A1
Figure 47: RF ID Code Display
D6412/D4412 Installation Guide
Page 57
Point
Number
Pt9
Pt9.
D6412/D4412
45349D
Advertisement
Table of Contents
