Sealey VS2005.V3 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instruction Wear eye
manual protection
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
‰
WARNING! Always use caution when working around fuel systems. The fuel in the fuel rail may be pressurised even if the engine is not
‰
running.
IMPORTANT: These instructions are provided as a guide only. Always refer to the vehicle manufacturer's service instructions,or a
‰
proprietary manual, to establish the current procedure and data, also any warnings or cautions particular to the vehicle.
DO NOT use the set if any parts are missing or damaged.
8
DO NOT use this tool for any purpose other than that for which it is designed.
8
Switch off vehicle's ignition and disconnect the battery before commencing work under the bonnet.
9
Never lay tools on the vehicle's battery. This may short the terminals
8
together, causing harm to yourself, the tools, or the battery.
Operate in a well ventilated area. DO NOT inhale fuel vapours.
9
Wear approved eye protection. A full range of personal
9
safety equipment is available from your Sealey stockist.
Wear suitable clothing to avoid snagging. DO NOT wear
9
jewellery and tie back long hair.
Keep children and other unauthorised persons away from
9
the working area.
Keep yourself, tools, and test equipment away from hot engine parts.
9
Always keep a fire extinguisher close by, that is suitable for
9
fuel/electrical/chemical fires.
NEVER smoke or have open flames near vehicle.
8
Always relieve fuel pressure before disconnecting fuel
9
lines from injectors.
Use a rag to cover fuel line fittings, when connecting or
9
disconnecting fuel lines. Avoid contact with fuel.
Clean up all fuel spills immediately and dispose of all rags properly.
9
Maintain the tool components in good and clean condition
9
for best and safest performance.
When work on the vehicle is finished, ensure all connections
9
on vehicle are restored, and that there are no tools left in the
engine bay.
Replace tools in the carrying case and store in a safe, dry,
9
childproof location.
2. INTRODUCTION
Comprehensive set for removing Citroen/Peugeot 2.0/2.2HDi 16v
fuel injectors. Allows the removal of seized injectors without the need
to remove the cylinder head. Bridge fits perfectly on the cylinder head
preventing damage to the area surrounding the injector.
3. CONTENTS (fig.1)
1 Bridge
2 3 x Bridge Legs
3 2 x Force Screws - Thread 17mm, 25mm x Pitch 1mm
4 Force Screw Nut
5 Injector Sockets 25mm, 29mm
6 Security Hex Key - ½"sq. drive
© Jack Sealey Limited
DIESEL INJECTOR PULLER
CITROEN/PEUGEOT
VS2005.V3
Model no:
Wear protective
Wear protective
clothing
gloves
Original Language Version
Wear protective
footwear
fig.1
fig.2
VS2005.V3 Issue:1 11/07/22