Adjustments For Surround Play - Kenwood 106VR Instruction Manual

To improve the feeling of presence in the surround modes.
■ 7. various parameters of each surround mode can be set up
^ according to the speaker system used as well as to the
environmental of the listening room. The following proce¬
dure let you set the parameters of the surround mode (DOLBY
PRO LOGIC, DOLBY 3 STEREO).
Once the settings have been done, it is held in memory so re¬
adjustment is not necessary even after the mode has been
changed to other modes.
o c> o S
o f±i o
o tti ct; cb
tf) £3 cS a
s &
0
*
£5 # B ^
1D6VR/105VR(Eo)
C3 0-0
Keys or controls to be used in this ooeration
Adjustments for surround play
Select the DOLBY PRO LOGIC surround mode.
• Select a surround mode according to the played source and your
system components
Lights
Lj Lj til nr T r
I r U C O X u
Each press of
CENTER MODE
key switches the modes as follows
NORMAL
WIDEBAND
PHANTOM
When the center speaker is a compact speaker
When the center speaker is a large speaker.
When no center speaker is used
O
Press the SETUP key (on the remote
control unit).
O
Adjust the front speaker (left & right)
levels so that the left and right levels are
identical.
To
decrease The
le*t channel sount
To decrease the
rignt chanr'el souna
O Press the SETUP key again to establish
the setup.
After this, the unit enters the condition
for "□ Adjust the volume level of each
speaker".
Adjustment procedure: Each press of the
SETUP
key switches the
adjusted items as shown below
B Adjusting the front speaker balance
□ Adjusting the volume level of each speaker
□ Adjusting the delay time
— End of setup
To cancel setup in the middle, press the
SETUP
key repeatedly until the
setup mode is cancelled
Left speaker
position
Center position Right speaker
indication position
I SURROUND
^ n „ ^
I
Balance setup