Kenwood 1090VR Instruction Manual page 39

THEME
TY /SAT/VID INFO ALT AUD
"495 REPEAT RANDOM
DISPLAY
5 | Press POWER, and check to see that the
component you want to control turns on.
—
POWER 1/8
mil
icon)
of 2
290
2000 : so]
000020 6 @
300°C
a Press the ENT key to store the code you
have just input.
The backlight flashes twice.
| ae ROOM B
| ENT
|
tO
Repeat steps 3 to 6 for all components you
want to control.
FE} Hold down the ENT key until the backlight
flashes twice.
1OS0VR [En/K}
¢ Example: Press 5258 to register a LD player made by KENWOOD.
¢ The backlight flashes once each time a number is entered.
* lf an invalid setup code is entered the remote will output one iong blink,
disregard that code and return to the beginning of step 4.
* If you push an invalid key, the remote will exit the setup mode
¢ PLAY or TUNING/SKIP (+/-) can also be used instead of POWER.
¢ lf the component does not react, and there is more than one setup
code, enter another setup code and try again.
¢ If the component is already on, pressing POWER will turn it off.
* This code replaces any previous setup codes entered for the respective
component.
¢ lf you have components that are not remote controllable, like a record
player (etc.), you will need to register a Non-IR code at the respective
input. This keeps the respective input in the remote control's cyclic list
so you can select it using the remote control. Please consult the
owner's manual of the components you are connecting for information
regarding remote controllability. The list of Non-IR codes is included at
the beginning of the Set up code chart.
-
~ 49.
¢ This operation should take about 3 seconds.
* Once registered, the dispiay on the receiver shows the component
type instead of the default input name.
Example: if you register a VCR at the VIDEO 1 jacks, "VCR" appears
instead of "VIDEO 1(SAT)".
* Both the default input name and the component type (i.e., " VIDEO1
"VCR'") are shown in the on screen display when the OSD made is set
to ON. ~ 32.
¢ After initial setup, any VIDEO (VIDEO 1, 2, 3, 4) or TV (TV1, TV2, CABLE)
inputs that have not been programmed with a setup code or Non-iR
code are deleted from the cyclic list (except for the "AV AUX" VIDEO
input). The PHONO input will be deleted if a Non-IR code was not
registered.
¢ The INPUT SELECTOR on the front panei of the receiver always cycles
through ail inputs.
ri