Table of Contents
Advertisement
Notes :
14
8. Turn off the OPERATE switch.
The @"
indicator
will come on.
Notes:
1. If the
erase
prevention
tab
is removed,
the
cassette is ejected automatically and "©'' indi-
cation will flash.
Stick a piece of cellophane tape
over the erase prevention hole on the cassette to
enable recording.
2. The '®"
indication will flash, if a cassette is not
inserted.
To clear a programme
1. Press the SET
button (Forward)
until desired
pro-
gramme indicator flashes.
Then start and stop time
appear on the display.
2. Press the CLEAR button.
The display returns the clock time display to show
that the programming has been cleared.
Be sure to
press the CLEAR button while the display shows the
start and stop time.
The programming
does not
clear if the CLEAR
button
is pressed when
the
display returns the clock time display.
To check programming
Press the SET button (Forward).
The programme
indicator ''[]]" flashes.
If the pro-
gramme No. 1 has been already programmed, both start
and stop times are displayed in a few seconds.
The
display then automatically returns to the present time of
day.
~~ —
~~,
par
a
—
cx
Programming errors
If programmes
overlap,
the VTR
will select the pro-
gramme with the earliest start time.
When
that pro-
gramme is over, the VTR will switch to the next pro-
gramme.
If the start times are the same, the VTR will
select the programmes in numerical order.
Advertisement
Table of Contents
