Table of Contents
Advertisement
MENU SETUP
Some functions on this radiotelephone are selected or
configured via a software-controlled Menu instead of
physical controls on the radiotelephone. Once familiar
with the Menu system, you will appreciate the versatility
it offers.
CHANGING MENU SETTINGS
| The [MENU] button must be activated by your
;
Dealer to function as described here.
The following procedure explains how to check or
change any of the Menu items.
1
Press [MENU].
2
Press [MODE] or [DATA] to select the desired Menu
number.
¢
[DATA] increments the Menu number; [MODE]
decrements the Menu number.
«
Amessage that briefly describes the selected
Menu item scrolls. This message can be
interrupted by turning the CHANNEL selector.
POWE
3
Turnthe CHANNEL selector to choose the desired
selection for the Menu number.
4
Press [MENU] again to exit Menu mode.
Settings for Transmit Power and Channel Lockout can
only be done by accessing Menu Setup. Also, the
settings for these functions apply only to the channel
selected at the time the setting is changed. Therefore,
before changing these functions, first select the
applicable channel.
Refer to additional information for
Channel Lockout on page 11.
10
MENU CONFIGURATION
Note:
@
Menu Nos. 08~15 may be unavailable depending on the Dealer
Settings.
@
Without the optional KPE-1 Selective Cail Unit installed, Menu
Nos. 06 and 07 can be accessed, but they cannot be used.
:
ow ea
NB
(Noise Blanker)
OFF/ ON
Alphanumeric display
OFF/ ON
2
k
Memory
channel
OFF/
05
Busy stop
Time operated (TO)/
Carrier operated (CO)
[06 | Selesioncat
| OFF/ON |
Identification code
Foe | wvcode | vm o00-000 |
Foe | wBote | ven 00-000
AAAAAAA~ZZZZZZZ,
0000000~9999999,
:
1*%<" is used as a wild card.
miscellaneous symbols
AAAAAAA~ZZZZZZZ,
0000000~9999999,
miscellaneous symbols
AAAAAAA~ZZZ2Z22Z2ZZ,
0000000~9999999,
miscellaneous symbols
AAAAAAA~ZZZ2ZZZZ,
0000000~9999999,
miscellaneous symbols
Note:
Default selections are shown in bold face in the above table.
MEMORY BACKUP
This radiotelephone contains an EEPROM to retain
channel data for channels 1~10. Turning OFF the
POWER switch, or a power failure, will not erase this
memory.
A lithium battery is installed that preserves Display and
setting data whether the radiotelephone is switched ON
or OFF. The lithium battery should last for
approximately five years. When the battery discharges,
erratic information may appear on the Display. Your
KENWOOD Dealer should replace the lithium battery
when the battery becomes discharged.
Advertisement
Table of Contents
