Kenwood 107VR Instruction Manual page 9

SURROUND
nd:cator
3 STEREO
indicator
Sascieetcti
AOZVR [En]
MEMORY indicator
Source Dect
iaicator
TAPE 2 indicator al
TAPE 2
N.B Ait —__-N.B. ST-
indi
——_ DSP 'naicate:
Broadcast pane {-
inaicators
6 90 oY eg
STEREO
indicate'
Frequency d:sp'ay.
Input display
Preset charne: display
Surround moae display
TUNED indicator
| AUTO tunirg/AUTO
stereo reception indicator
a) °
|
KENWCOD
| mmoigce | ago
ep ee
| OSI)
a
Logs
5 6
| 4 6000 © 6 | boo @
QPOWER key @SPEAKERS A/B keys @N.B. key ~ 8
Press to switch tne power ON and OFF
@ STANDBY indicator
© SRS 30 indicator
Lignts wren the SRS 3D system is ON
OSPEAKERS indicator
rights when the speakers are ON
OSTEREO key 24
Press to turn the surround mode OFF
@DOLBY PRO LOGIC key ~22
@DOLBY 3 STEREO key - 24
OSRS 3D key 26
O INPUT SELECTOR knob
Rotate to select the input source
@VOLUME CONTROL knob
@®PHONES jack
Piug meadpnones inte ts jack
@AUTO key
Press to seiect tne tuning mode from the
3.t9 Tuning and manual! tuning modes —.17
Press and hoc the AUTO key for more tnar
2 ds 10 sw tch the VIDEO1 dispiay to
r-nput display cars
About the STANDBY indicator
Press to select the A and/or B speakers
system
@ DIRECT key = 38,
Press when tuning a broadcast station by
entering the digits of its frequencies
@ MEMORY key - 12,
Press when registering a broadcast sta-
tion in the preset memory
@ Numeric keys (1 to 0, +10)
@BAND key AL
Press to sw.tch the broadcasting band
@DISPLAY key
Press to switch the displayed information
between the surround mode display and
input selector display
Press and hold the DISPLAY key for more
thar. 2 seconds to switch the display bright-
ness
@ TUNING keys (v7, A}
Press to select a radio station
@ TAPE 2 MONITOR key 2
Press to monitor the sound being r
corded, etc
Press to compensate for the insuffi
ciency in the base sound
@DSP LOGIC key
@DSP key
@SOURCE DIRECT key
Press to listen to the source sound with
higher sound quality
@AV AUX (VIDEO) input terminals
Video input terminal
@ AV AUX (AUDIO) input terminals
Audio input terminal
Tris ur-t has a STANDBY ndicator, tne lignting of whicn indicates tnat a small amount of current is supplied to back up the internal memory of the unit
This status 1s "elerred to as the standby mode of the unt in this mode, the power of the unit can be switched ON from the remote control unit
Vher tne uni is not to be used for a long perio of t-™e, unpiug the power cord from the power outlet