General Instructions - AEG MICROMAT COMBI 625 Operating Instructions Manual

The turntable should only be turned off if you are using rec¬
tangular ovenware which is larger than the turntable is (so that
there Is a risk of it jamming).
If the turntable is to be turned off during operation, the process
has to be interrupted by
pressing the C button
twice. Then
you can switch the turntable off by
pressing the button,
and
any other setting can also be altered. The symbol will appear in
the display to indicate that the turntable has been switched off.
Press the
start button
<I> and the pre-set operation will start run¬
ning again.
If the oven door is opened during operation (e.g. for stirring), the
settings remain unchanged. The relevant indication starts to flash
in the display.
When the door has been closed and the start button O
pressed, the remaining running time automatically starts running
again. The operational function display lights up.
AH pre-set operating functions can be stopped momentarily by
pressing the
C
button once. The operating functions are in¬
terrupted if the
C
button is pressed twice.
When wrong settings are done, generally the letter "E" will
appear in the display. The
C
button has to be pressed to
permit correction and new settings are possible.
The roof of the interior will be easier to keep clean if the glass fat
drip-tray is always inserted above the grill to act as a splash-
prevention cover. This will in turn be easier to clean if it is left to
soak in warm water and washing-up liquid immediately after it has
been used.
Times can be set as follows:
up to 20 seconds
from 20 seconds upwards
from 1 minute upwards
from 2 minutes upwards
from 10 minutes upwards
in 5-second steps
in 10-second steps
in 15-second steps
in 30-second steps
in 1-minute steps.
Note
Opening the
door during
operation
General notes
General
racommen-
dations
Notes on
setting
the times
15