Table of Contents
Advertisement
| CONTENTS
INSTALLATION
ignatasiicenaltiad nanilnkewaneininiennai aumatneeararenie
4
MAINTENANCE. sian cceststaxsvencaacectavnscs
HANDLING CASSETTE TAPES...........cccsscssssssesesstenscnsssussensnseseevees
5
CONNECTIONS wictctecl tet
6
FRONT: PANEL FACILITIES sacieccsctcssisyaesnstantetainctnstraicvidiysteareostesess
7
jcyiraucatnetaaseauimscnstuapatvehsuners
SINGLE PLAY BACK acicadeuashutten
a
iSite
RECORDING iisckiescvsipies sexvicnsie cicedysltntuatstutansatinininestledas reatiachiamistaeteiaes 13
RECORDING USING MICROPHONE (CT-W602R only)............ 13
ERASING:A TAPE. .itiieted cocrecteanseviedeciesiicectinisiesiicaginenn 13
AUTO BLE TUNING (CT-W620R/CT-W602R only) ........sceeees 14
RELAY RECORDING (CT-W602R only) .........::essssesesetseeeeeeeenes 15
CD - DECK SYNCHRO RECORDING ....... cc ceesesceeeeereeeeeeneeennens 16
TAPE COPYING s, sscuiiiiss stisicccuniits vearsiiert ed eeaz tention neds avenan vaca nnntaitetaes 17
RECORDING AND PLAYBACK USING AN AUDIO TIMER............. 18
TROUBLESHOOTING oe.t.ceccovcscttinmtacvessavansnnncsuneantteihanamenataanuincs 19
SPECIFICATIONS cavevesexnosansassscansase
CT-W620R/CT-W602R/CT-W5OQR ......sseseseseeceeseeeeseeteteeeeesenenenee 21
CT-WA20R/CT-WAO2R sit satadesdecst ascites sttaateotestolcensiodaaqab
INSTALLATION
When
installing
the deck,
avoid
locations
with
high temperatures
or humidity,
and
make
sure
that the deck receives adequate ventilation.
@ Do not install the deck in locations subject to direct sunlight, or
near a space heater or other heating device, as this may cause
damage to the finish or internal parts.
H@ Malfunctions may also result if the deck is installed in an ex-
cessively humid
or dusty location. Avoid
installing the deck
next to kitchen
counters
or other
locations subject to oily
smoke or humidity.
M@ If the deck is placed directly on top of an amplifier, it may pick
up humming or other noise. Also, if the amplifier generates a
large amount of heat, the deck may malfunction.
@ If the deck is located near a television set, it may pick up inter-
ference noise, which will be recorded as a whistling sound on
the tape. If this happens, move the deck further away from the
television set or turn the television set off when operating the
deck.
M@ Do not place a cloth over the deck, or block the ventilation slots
in any way. The ventilation slots on this deck are necessary to
keep internal parts cool. If they are blocked, the deck may mal-
function.
CONDENSATION
|
When the deck is moved from a cold location to a warm location,
or when the temperature of the room changes suddenly, conden-
sation may form on the mechanical parts. This can adversely af-
fect the performance of the deck. If this occurs, wait for about one
hour to allow the deck to adjust to the room temperature. To pre-
vent condensation when
heating a room, raise the temperature
slowly.
4
<RRB1130>
En
MAINTENANCE
Erase head
Capstan
A) Ly, By
Pinch roller
Rec/play head
Capstan
Pinch roller
CLEANING THE HEADS, PINCH ROLLERS
AND CAPSTANS
The heads, pinch rollers and capstans are likely to get dirty quite
easily. If these parts, particularly the heads, get dirty, the high fre-
quency components of a recording will not be reproduced and the
stereo balance will be impaired, resulting in a deterioration of the
playback sound. It is therefore recommended
that the head sec-
tion be cleaned regularly.
1. Set the POWER switch to OFF.
2. Press the eject button to open the cassette door.
3. Dip a cleaning swab in cleaning fluid and use it to wipe the
heads, capstans and pinch rollers.
NOTE:
After cleaning the head section, do not load a tape until the clean-
ing fluid has dried completely (about two or three minutes).
DEMAGNETIZING THE HEADS
After using the cassette deck for a period of time, the heads will
become magnetized. The same effect will occur if a magnetized
screwdriver,
magnet or other magnetized
object is brought too
close to the heads. When the heads become magnetized, high-fre-
quency sounds will be lost during recording or playback, and in-
terference noise may also occur. The heads should be regularly
demagnetized with a head demagnetizer, which can be purchased
at most audio stores.
When
demagnetizing
the heads,
make
sure
that the POWER
switch of the cassette deck is set to ON. However, be sure to turn
down the amplifier's volume control to its lower position, and dis-
connect any headphones from their headphones jack. For detailed
instructions, refer to the operating instructions of the head de-
magnetizer.
:
CLEANING THE FRONT PANEL
Clean
the deck
regularly
with
a soft cloth.
If the front
panel
becomes soiled, moisten a soft cloth with a weak solution of neu-
tral detergent (diluted in five to six parts water), wring the cloth
well, and wipe the panel clean. Never use volatile cleaners like
thinners, benzine or alcoho! because they will damage the panel
finish.
Advertisement
Table of Contents
