Sealey LED1000 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
1.1. GENERAL
Ensure the lamp is fully charged before initial use.
9
DO NOT turn the lamp on when it is being charged.
8
DO NOT shine directly into your, another person's or an animal's eyes.
8
DO NOT allow children to use the lamp.
8
DO NOT handle or move the lamp whilst it is being charged.
8
DO NOT use the lamp if you suspect that the battery, the lamp casing or the cable is damaged. Consult your Sealey Stockist.
8
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery,
8
subsequently recharge the battery at least once every six months of non-use.
1.2. BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
‰
DO NOT Attempt to open, dismantle, modify or service the battery pack.
8
DO NOT Crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT Expose to temperatures above 40°C or below -10°C.
8
DO NOT Expose to direct sunlight for long periods of time.
8
DO NOT Expose to moisture.
8
WARNING! DO NOT place the lamp face down while in use.
‰
If the electrolyte in the cells gets on your skin, wash thoroughly with soap and water. If it gets in your eyes, rinse thoroughly with
9
cool water and seek immediate medical attention.
2. INTRODUCTION
Compact, lightweight design with a large 1000lm output. Made with a tough ABS plastic housing with flip-out magnetic bracket.
Includes small carabiner, which can be used when no ferrous surface is available for additional storage and application solutions.
Magnetic bracket can be angled at a range of 180° making it simple and easy to direct up to 1000 lumens of light. Three light output
settings; low, high and flashing. Features LED battery level indicator. Fitted with a high quality 3.7V 2Ah lithium polymer battery.
Charges via a USB-C lead. (Supplied, with charge time of 4 hours). IP rating: IPX4.
3. SPECIFICATION
Model No.: ....................................................... LED1000
Battery: ................................................3.7V 2Ah Li-Poly
Charging Time: .........................................................4hr
IP Rating ................................................................ IPX4
LED Type: ...................................................... 10W COB
Length: ................................................................... 9cm
Lumen Output .................................................... 1000lm
Operating time: ......................................................4.5hr
The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.We
will provide warranty against mechanical and electrical defect for a period of one year. This does not cover fair wear and tear.If the
battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will
not replace the battery regardless of whether it is less than one year old.
NOTE: The lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without
another charge.
© Jack Sealey Limited
10W COB LED RECHARGEABLE POCKET
FLOODLIGHT 1000 LUMENS, WITH FLIP OUT
MAGNETIC BRACKET
LED1000
MODEL NO:
Original Language Version LED1000 Issue 2 (3) 31/10/23