Lenovo smart lock A1 User Manual page 3

2 : ENTER TO ADMINISTRATOR MODE
3 : ADDING USER
3.1 : ADDING OF FINGERPRINT
1. Press [*] twice and key in administrator Pincode / Fingerprint.
2. Press 1 to enter "Adding of user" mode
3. Follow voice prompt, use the same fingerprint 6X over the sensor area to capture different angles
of fingerprint till it is successful
3.2 : ADDING OF PINCODE
1. Press [*] twice + admin pincode to enter administrator mode, and press [1] to add user.
2. Enter the 6-digit password according to the voice prompt, press [#] to end.
3. You will be required to enter the 6-digit password again. "Enter the same password again, press
[#] to confirm, and hear the voice prompt "Added successfully".
3.3 : ADDING OF RFID TAG
1. Press [*] twice + admin pincode to enter administrator mode, and press [1] to add user.
2. Place your RFID tag near the card sign on front panel, press [#] to confirm, and hear the voice
prompt "Added successfully".
3.4 : ERASE ALL WARNING: ALL WILL BE DELETED
1. Press [*] twice + admin pincode to enter administrator mode, and press [2] and [1] to delete ALL.
2. After all deleted, all previously created Fingerprints, Pincode and RFID Tags will be deleted, please
operate with caution.
3.5 : ERASE SPECIFIC FINGERPRINT / PINCODE / RFID TAG
1. Press [*] twice + admin pincode to enter administrator mode, and press [2] and [2] to delete
specific pincode / RFID tag / fingerprint.
2. Enter OR place "to be delete" Fingerprint / Pincode / RFID Tag
Touch the front pad area, the touchpad light is on, press [*] twice in a
row to enter the administrator management mode.
The first time you enter, you need to configure an administrator first,
and you can add it according to the voice prompts. Once administrator
has been added, you can enter by verifying the administrator's finger-
print or administrator's password.