Installing The Equipment - Nokia Alfaskop TT/386 User Manual

Installation
Installing the Equipment
Note: It is important that you follow the instructions closely. Before
beginning, record all information marked on the SETUP
INFORMATION sticker on the back panel of the system unit on a
special note. You will need this information when you run the Setup
program. Make sure that the power switch on the back panel of the
system unit is in "0" position (i.e. the power is OFF). The key on the
front panel of the system unit must be in STOP position. The monitor
and the possible printer must also be turned OFF. Ignoring this
notice may cause damage to the computer.
The Figure below shows the back panel of the system unit with the
receptacles for the various cables and power cords. Remember to
check that the power switch of the system unit is in "0" position.
Connect the cables and power cords in the following order, always
leaving the power cord of the system unit last.
Parallel port
Serial port
$
lZj
Monitor
power cord
NDC R
display adapter Keyboard cable
2-4