Table of Contents
Advertisement
29
TAKING A READING
Stay quiet and relax while taking measurements
Place the storage case under your arm.
(Referto "FOR ACCURATE
MEASUREMENTS" on pp.27 and 28)
PreSS the 开始 /结束 button.
e All displays will be shown for approximately
2 seconds.
®Pressurization will start automatically.
e@The heart mark Pwill blink when pulse is
detected during pressurization.
Since measurements are performed duing
pressurization, there may be changes in
operating sounds or the pressurization
rate during pressurization. This is normal
and is not a malfunction
When measurement has been completed,
the blood pressure value and
pulse rate will be displayed.
Pressure will be automatically released from
the pressure cuff.
® The blood pressure values and pulse
number are displayed at the same time .
Blood pressure values are displayed
alternately in mmHg and kPa units.
e |f the measured value is in the high
blood pressure region, the values will
blink (for approximately 6 seconds).
(For how to read the blood pressure
display, see p.32)
The M mark will blink.
(For measurement values which can
be stored, see p .33
©The pulse rate value is the beats per
minute calculated based on the pulse
rate during measurement.
To switch off the blood pressure monitor,
Press the 开始 /结束 button.
elf you forget to switch off the blood
pressure monitor ,it will switch off
automatically after approximately 5
minutes.
MOVEMENTDETECTION FUNCTION
If the wrist bound with sleeve strap flexes unconsciously during the
measurement, the blood pressure results may be inaccurate at times.
The "Movement Detection Function" is a function that detects
excess pressure on the wrist strap caused by movement of the
user's hand or wrist during blood pressure measurement and
shows the "Movement Detection" symbol in the disply when this
occurs.
elf the "Movement Detection" symbol blinks, please resume the
proper position of your arm (see pp.27 and 28).
eThe "Movement Detection" symbol blink if the body moves during
blood pressure measurement . When the result is displayed and
body was moving during measurement, the "Movement Detection
symbol will also blink.
(When a saved result, measured while the body was moving, is selected, the
"Movement Detection" symbol will also blink.)
"Movement
Detection"
symbol display
Explanation
Body movement detected
e Involuntary flexure of hand or wrist.
e Overexertion of the hand or wrist.
® Movement of the hand or wrist etc.
Please resume the right position and
measure again(see pp.27 and 28).
Movement that may causeinaccurate
measurement result occurred:
eLarge degree of movement
® Multiple movements
Large degree of movement of the
hand or the wrist etc.
When "E" is displayed on the screen,
please measure again.
( "E" will be displayed when:)
e The fastener of sleeve strap is loose.
*This is a reference function that designed for accurate measurement.
In order to obtain more accurate blood pressure measurement results,
please measure for 2-3 times under static status even if the"Movement
Detection" symbol does not blink (see p.27).
30
Advertisement
Table of Contents
