Table of Contents
Advertisement
Available languages
Available languages
4,
ASSEMBLY
The chipper shredder was shipped with one end of the support brace already
Attaching The Bag
secured to the lower frame. Loosen but do not remove the bolts securing the
brace to the frame.
1.
Toattach the bag:
A. Align the holes in the chute with the holes in the top of the brace and
A,
Place the opening of the bag completely over the chute deflector.
attach brace to chipper chute with hardware previously removed. The
B.
Pull on the drawstring until the bag is tight around chute deflector
flat washers should be placed under the bolt heads and against the
opening.
inside surface of the plastic chipper chute. Tighten securely. See Figure 7.
C.
Clip drawstring back on itself, tight against chute deflector to secure
(—
\
into position. See Figure 8.
Figure 7
Figure 8
Tighten the bolts securing the support brace to the frame.
Tighten the three nuts on the weld studs holding the chipper chute to
the impeller housing.
Advertisement
Table of Contents
