Table of Contents
Advertisement
Problem
The display shows
. All buttons are
inactive, except the the
On/Off
.
The appliance makes
an unusual noise and
vibrates.
The programme dura‐
tion increases or de‐
creases during pro‐
gramme execution.
The washing results
are not satisfactory.
Too much foam in the
drum during the wash‐
ing cycle.
The detergent/fabric
softener level does not
decrease in the Auto‐
Dose tanks after wash‐
ing.
The drum light does
not go on.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
Possible solution
•
The appliance is downloading any available updates. Wait un‐
til the update process is complete. If you deactivate the appli‐
ance during update, it resumes when you activate the appli‐
ance again.
•
Make sure the levelling of the appliance is correct. Refer to
"Installation instruction".
•
Make sure that the packaging and/or the transit bolts are re‐
moved. Refer to "Installation instruction".
•
Add more laundry in the drum. The load may be too small.
•
The ProSense Technology is able to adjust the programme
duration according to the type and the laundry load size. Refer
to "The ProSense Technology load detection" in "Daily Use"
chapter.
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before
you wash the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
When using AutoDose tanks, make sure that they are not
empty.
•
When using AutoDose tanks, verify the pre-set detergent/
fabric softener dosage. Refer to "Basic setting" paragraph in
"The AutoDose Technology" chapter.
•
Make sure that you have cleaned the AutoDose tanks before
using different brand and type of detergent, fabric softener or
other additives.
•
Reduce the quantity of detergent or the number of tablets or
single-dose detergents.
•
When using AutoDose tanks, verify the pre-set detergent/
fabric softener dosage. Refer to "Basic setting" paragraph in
"The AutoDose Technology" chapter.
•
This is normal: tanks are quite large and detergent consump‐
tion may be not so evident.
•
Make sure that the LED lamp is not burned. To replace it, con‐
tact the Authorised Service Centre.
ENGLISH
55
Advertisement
Table of Contents
