Before First Use; Operation; Placing The Product - Silvercrest SWKK 3000 B1 Operation And Safety Notes

If you notice any smoke or
unusual noises, immediately
disconnect the product from
the power supply . Have the
product checked by a specialist
before continued use .
mWARNING! Do not use
the product if the water kettle
shows cracks or other signs of
damages .

Placing the product

The product must not be placed
directly below a power supply .
Always use the product on a
flat, stable, clean, heat-resistant
and dry surface .

Operation

The product shall only be used
with the supplied base .
Do not overfill the product . If
the product is overfilled, boiling
water may be ejected . Do not
operate the product without
water . The fill level of the
product must be between the
MIN and MAX marks on the
water gauge .
Cleaning and storage
The product shall not be
exposed to any dripping or
splashing water .
Disconnect the product from the
power supply before cleaning
and when not in use .
Refer to the "Cleaning and
care" section for instructions on
how to clean the product .
˜ Before first use
Remove all the packaging materials .
Clean the product (see "Cleaning and care") .
Boil the maximum water volume of 1 .7 litres
(see „Operation") . After boiling, discard the
water to remove any production and transport
residues .
GB/IE 21