Panasonic JU-475-4 Service Manual page 22

When the carriage is on an outer-most track :
Provide a clearance of about 1-
mm between the Side 0 and Side
1 approximatelv within this
range.
Align the center with line A. 777
When the carriage is on an inner-most track :
Inner-most
o AJ
Provide a clearance of about 1-
mm between the Side 0 and Side
1 approximately within this Å
range.
Fig. 12-9-2 Pail Tail Leading
-20-
12.10 Drive Motor Removal and Installation
(1) Remove the cartridge guide assembly as
described in section 12.7.
(2) Remove the three drive motor mounting
screws and take off the drive motor from the
base.
(3) Reverse the above procedure to reinstall.
(4) After reinstallation, the adjustments necessary
upon reinstallation of the cartridge guide as
described in section 12.7.
Fig. 12-10 Drive Motor Removal