Page 3
NEC Electronics does not assume any liability for infringement of patents, copyrights or other intellectual property rights of third parties by or arising from the use of NEC Electronics products listed in this document or any other liability arising from the use of such products. No license, express, implied or otherwise, is granted under any patents, copyrights or other intellectual property rights of NEC Electronics or others.
Page 5
The information in this document is subject to change without notice. No part of this document may be copied or reproduced in any form or by any means without the prior written consent of NEC Engineering Ltd. and NEC Electronics Corp.
Boards and cables Please find the following boards and cables in the box. MCU Board x 2 RF Board x 2 Battery Adapter x 2 Cable x 2 CD-ROM and Documents Please find the following CD-ROM and documents. CD-ROM Board Set Up Guide License Agreement (this document)
BOARD SET-UP GUIDE Assembly Procedures (1) Connecting RF Board to MCU Board RF Board MCU Board Attention Caution Please make sure power is not connected during assembly UM U17585EE1V0UM00...
Page 8
BOARD SET-UP GUIDE (2) Connection of the battery adapter MCU Board Battery Adapter Attention Caution Please make sure the red wire is on the left side. 「+」 「-」 Attention Caution Please do not connect a battery in the reversed direction. −...
Page 9
BOARD SET-UP GUIDE (3) Connection of the USB cable MCU Board USB Cable Attention Caution Please connect the USB cable, after the RF board is attached. − Please set the JP1 (Jumper 1) to the USB to supply power from USB cable. −...
BOARD SET-UP GUIDE Specifications Product Name ZB78K0/KF1+CC Protocol IEEE 802.15.4 Rate Max 250Kbps, depends on the environment Interfaces UART ・TxD, RxD, Two Wire UART Serial ・Baud Rate 38.4kbps/8 bits/No Parity/1 Stop Bit A/D I/F CSI I/F GPIO I/F USB I/F Power Supply 006P Battery (9.0V) or 5.0V±5% via USB cable...