Set-Up - Sony KV-25DXR Service Manual

Cable compatible tv
Table of Contents

Advertisement

1-3. SET-UP
SPEAKERS
Placement
Attaching the speakers to the TV
Right speaker
(Rear)
/
(1===-===ti/
r,._
Left speaker
Set BASS BOOST to ON
SPEAKER terminals
Turn the knobs on both sides
counterclockwise, adjust the
angle and then turn the knobs
clockwise to lock the speaker
in position.
The "APM" label should be right side up.
If desired, the speakers can be placed separately from
the TV by unfolding the stand.
Unfold
Di
• Adjust the angle of the speakers, for best sound pro-
duction.
Caution
• Be sure to use speakers that are rated at 8-ohm im-
pedance with normal power holding capacity of
more than 10W.
• Make sure that none of the wire strands stick out,
making contact with the neighboring speaker ter-
minals.
• If you have connected a pair of speakers other than
the supplied speakers, make sure to place the TV
set at a distance away from the speakers so that it
will not be affected by the speaker magnets. If a
temporary proximity to magnets should cause por-
tions of the picture to have poor color, turn the
POWER off, and after about 10 minutes, turn it on
again.
Speakers with low magnetic flux leakage such as the SS-
X10A speaker systems (optional) may be placed near the set.
KV-25DXR
RM-727/APM-X3U
Connection
The speaker cord marked with a red line should be con-
nected to the EB (red) terminal and the cord unmarked to
the
8
(black) terminal for correct in-phase operation.
Right speaker
:I
While pressing the
button, insert the
wire into the hole,
then release the
button.
Pull lightly on the
connection to make
sure it is secure.
Left speaker
Speaker cords
If desired, larger 8-ohm speakers can be used as long as
they are rated at 8-ohm impedance.
Expose and twist the wire ends of the cords of your
speakers as illustrated below, and make the correct EB
8
connections. For large speakers, set BASS BOOST
switch on the TV to "OFF" to prevent excessive bass.
5/a" (15mm)
Strip about
5
/a" (15mm)
of the wire insulation
from the ends ...
and then twist the
wire ends.
• Never connect an amplifier and this TV simulta-
neously to the speakers as this may damage the TV.
-7-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rm-727Apm-x3u

Table of Contents