Table of Contents
Advertisement
TO USE THE COMPONENT CONNECTED TO THE
ADAPTOR TERMINALS:
Connecting the dynamic expander to the adaptor makes it possible to
enjoy the dynamic expander's effects.
'Adaptor component
(Dynamic expander)
2x | ®» Gal W
FG
ante
nee es
»
MAN
——
OPERATIONS
[Connection]
(1) Set the POWER
switch to OFF.
(2) Remove the two connecting bars from the adaptor
terminals.
ek
Connecting bars
NOTE:
Always remember to keep the connecting bars in place when these
terminals are not being used.
(3) Connect the adaptor component in accordance with
the
connection
diagram
in the
section
''Con-
nections."
[Operation]
(1) Playback the source.
(2) Operate the adaptor component.
The sound compensated with the connected adaptor component
can be recorded on a cassette deck. Signals modified with an
adaptor component can be recorded on a cassette deck.
NOTE:
Be sure to perform this operation with the adaptor components power
switch in the ON position. Even when not using the adaptor component,
its power switch must be left ON. If the adaptor component is switched
OFF no sound will be produced or the playback sound will be distorted.
For details, refer to the adaptor component's operating instructions.
Using
the Optional
VSP-333
Digital Surround
Processor
lf you connect a VSP-333, the main unit can be used as the front
amplifier of a surround system.
@
«ey
VSP switch
© of
lo-o"
iin
RE)
© o1
{|
0-0" |
[Connecting]
(1) Set the power switch to OFF.
(2) Connect the VSP-333 input/output cord to amplifier.
Insert
the
connector
until
it locks,
thus
ensuring
that
it is
connected.
When
disconnecting
the connector,
pull it in the
opposite direction while pressing the left and right claws.
(3) The VSP switch should be in the FOR USE WITH
VSP-333 position.
NOTE:
° Be sure the VSP switch is in the WITHOUT VSP-333 position when
a VSP-333 is not connected. In the ON position there will be no sound.
° Even if the VSP-333 is connected,
if the VSP switch is in the
WITHOUT VSP-333 position, VSP-333 volume level adjustment will
not be possible.
[OPERATIONS]
(1) Playback the source.
(2) Operate the VSP-333.
NOTE:
Be sure to perform this operation with the VSP-333's power switch
in the ON position. Even when not using the VSP-333, its power switch
must be left ON. If the VSP-333 is switched OFF, no sound will be
produced, or the playback sound will be distorted.
For details, refer to the VSP-333's operating instructions.
Recording with the VSP-333 (optional) connected
Sound recording from sources such as VCR
1, VCR 2, and
VDP
connected to the VSP-333
input jacks is possible
withthe
cassette
deck,
but
be sure
the SA-1520's
FUNCTION
switches
are in a
position other than TAPE.
If you select TAPE with the FUNCTION
switches,
recording is not possible from sources
connected
to the
VSP-333.
15
<ARB1244>
Advertisement
Table of Contents
