CDP - C8ESD/C700/ C800
SECTION 2
ADJUSTMENTS
2-1. MECHANICAL
ADJUSTMENT
2-2.
BEFORE
ADJUSTMENTS
Chucking Arm
Height Adjustment
Note:
Follow the disassembly procedure in the numerical order given.
This adjustment should be parformed after the electrical adjustment
and on replacing adjusting screw, magnet, or chucking pulley.
1. Remove the case.
2. Remove the frontpanel assembly.
Procedure:
1. Set disc (YEDS-18) to the optical pick-up block.
(Fig. A)
2. Adjust the bracket (press pulley) to the center of the magnet
with adjusting screw. (Fig. B)
@ +K265
(2pes.)
disc table
adjusting screw
(+B3 x 25)
YEDS-18
bracket
(press pulley)
|
chucking yoke
@ front panel
+BV3<8
|
(C8ESD/C800)
i,
© + BVTP3 x 10 (3pes.)
3. Remove the disc table assembly.
YEDS-18
magnet
chucking pulley
Fig. B
Fig. A
eo
+ BVTP3 x 10 (2pes.)
© + BVTP3 x 10 (2pcs.)
| @ rein forcement (B)
Zs
© guide bracket
@ disc table assembly