Advertisement
WARNING! Only use this machine for its intended use.
‰
DO NOT use the grass trimmer without the guard.
8
DO NOT cut grass when it is wet. The best results are achieved with dry grass.
8
Always wear appropriate eye protection, ear protection, substantial footwear, gloves, long trousers whilst operating.
9
5.1.
Push the battery pack into the mount provided (fig.5).
5.2.
To remove the battery pack, press the battery pack button and pull the battery out.
5.3.
ADJUSTING THE ANGLE OF TILT OF THE GUIDE HANDLE
5.3.1. Press the button for the angle of tilt adjustment (fig.9). Now set the long handle to the required tilt. Release the button and allow the
handle to lock into position to fix the angle of tilt. Four different locking angles are possible.
5.4.
To switch on your grass trimmer press the safety lock-off (fig.6) and then press the On/Off switch (fig.6).
5.5.
To switch off your grass trimmer, let go of the On/Off switch.
WARNING! The blade will continue to spin for a few seconds after the ON/OFF switch is released.
‰
DO NOT allow the grass trimmer near the grass until the switch is pressed and the grass trimmer is in operation.
8
5.6.
To cut properly, swing the machine sideways while moving forwards. Keep the grass trimmer inclined at an angle of approx. 30° while you
do so (fig.7 & 8).
5.6.1. If the grass is long, the grass must be cut shorter in stages, starting from the tip (fig.10 & 11).
5.6.2. Use the guard hood to prevent unnecessary wear.
5.6.3. To avoid unnecessary wear, keep the grass trimmer away from hard objects.
5.7.
USING THE GRASS TRIMMER AS AN EDGE TRIMMER
5.8.
To cut the edges of lawns and flower beds, the grass trimmer can be converted as follows:
IMPORTANT: Remove the battery pack.
5.8.1. Push and turn the motor head through 90° in the required direction until it latches in place (fig.12).
5.8.2. Now the grass trimmer has been converted to an edge trimmer that cuts vertically.
6.
MAINTENANCE
WARNING! Before cleaning or performing any maintenance, pull out the battery pack.
‰
6.1.
CLEANING
6.1.1. Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it down with compressed air at low pressure.
6.1.2. Always clean the equipment immediately after use.
6.1.3. Clean the equipment regularly with a damp cloth and some mild soap. DO NOT use cleaning
agents or solvents, these may be aggressive to the plastic parts in the equipment. Ensure that no
water can get into the interior of the equipment. The ingress of water into an electric tool increases
the risk of an electric shock.
6.1.4. Use a brush to remove deposits from the safety guard.
6.2.
REPLACING THE BLADE
WARNING! Be sure to remove the battery pack before replacing.
‰
6.2.1. To remove the blade, push the blade inwards and remove it through the larger opening as shown
(fig.13).
6.2.2. To fit the new blade, proceed in reverse order. Make sure the blade locks into place correctly
(fig.14).
6.3.
STORAGE
6.3.1. Remove battery. Store carefully in a secure, dry place, out of the reach of children.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When
the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved
containers and dispose of the product and fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
Fig. 14
Fig. 16
sales@sealey.co.uk
Warning! Read these instructions carefully, be familiar with the co
use of the trimmer. Please keep the instructions safe for later use.
Original Language Version
Explanation of symbols on the trimmer (Fig.16)
Fig. 14
Fig. 15
Fig. 16
Warning! Read these instructions c
use of the trimmer. Please keep th
Explanation of symbols on the trim
General hazard safety alert.
www.sealey.co.uk
Read instruction manual.
CS20V
Issue 3 (H,1,3,F)
FIG.13
Fig
FIG.14
REGISTER YOUR
PURCHASE HERE
04/10/23
Advertisement
