Whirlpool ADG 699 Manual

GB ADG 699
Programme selection button
START button
The indicator lights up during operation, flashes when a fault
occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected programme and
options are cancelled. Main failure displays (repeated flashing of the
START indicator lamp) can be cancelled by RESETTING. Detailed
instructions are given in chapter 5 "What to do, in the event of...".
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:mm),
whereas with "Delayed start" selected it indicates the time
remaining until programme start (hh).
If "F .." appears on the display, see chapter 5 "What to do, in the event of.
Delayed start" button
Press the button (repeatedly) to delay the start of the programme.
Adjustable from 1 to 24 hours. With each press of the button, the
delayed start indicator increases by one hour and after 24 restarts
from 00. Then press the START button. The dishwasher will start
after the set time.
P
Programmes
1
Sensor +
2
Pre-Rinse
3
Glasses
4
Quickwash
5
Bio
6
Antibacterial
7
Nightrinse
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra functions,
sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the EN comparison test and other
tests, contact the following address: "nk_customer@whirlpool.com".
3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with. Standard NF EN 13697 - November 2001.
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1. OVERVIEW
Table 1.1.
Table of programmes
Selectable
extra
functions
40-70°C
cold
40°C
40°C
2)
50°C
3)
55°C
Detergent setting upon initial use and when using a different type of detergent
1. Select the third programme in the relative table.
2. Press the START button for approx. 7 sec. to change the display.
3. Using the START button, select the desired detergent:
Display shows: 2 -1 = 2 in 1, 3 -1 = 3 in 1, 4 -1 = other combined action
detergents (in this way, the rinse aid and/or salt indicator is deactivated).
Display shows OFF = Powder detergent (factory setting).
(rinse aid level and salt level indicator activated).
4. Switch the appliance off and then switch it on again. The selected detergent
type will be indicated on the display for approx. 3 sec .
Half Load/Multizone button
Load the top or bottom rack only.
press once = wash top rack (the indicator/symbol lights up)
press twice = wash bottom rack (the indicator/symbol lights up)
press 3 times = Off (Half load/Multizone deactivated).
When washing without the top rack, press the "Half load" (i.e.
"wash bottom rack") button. "twice (the corresponding indicator/
symbol lights up).
Power Clean
High pressure with an additional jet for better washing results and
greater bottom rack load flexibility.
On / Off Button
Loading instructions
Normally or heavily soiled crockery, including
pots and pans.
Crockery to be washed later.
Light soiling, for example glasses and cups.
Lightly soiled crockery, without dry residuals.
Normally soiled crockery. Energy-saving
programme.
Normally or heavily soiled crockery, with
additional antibacterial wash. An interruption of
the programme (e.g. due to door opening) can
compromise elimination of germs.
Normally soiled crockery, gentle and quiet
(39 dbA) thanks to the lower pressure jet.
Detergent
Consumption
dispenser
large small Litres kWh Minutes
X X 7-17 0.99-1.58 65-170 ±
— — 4.0 0.03 14 ±
X — 10.0 0.85 100 ±
X — 10.0 0.65 30 ±
X X 11.0 1.05 155 ±
X X 13.0 1.50 115 ±
X X 13.0 1.20 290 ±
5019 396 01098
1)
1)
1)
1)
1)
1)
1)
1)
1