Table of Contents
Advertisement
~6]
Motor brake spacing
★Adjust the brake spacing when about two years have passed. And also adjust when the brake generates abnormal
noises and does not stop stably.
Adjustment Procedures
1. It is recommended that you remove the motor pulley and measure the brake spacing in advance. The brake spacing
is factory set at approx. 0.2 mm.
2. Remove the screw
O
and the pulley cover ©.
3. Remove the V belt.
4. Remove the nut © and the motor pulley assembly ©.
5. Remove the washer © from the shaft © so that the brake spacing becomes 0.2 mm. The washer © is available
with the thickness, 0.1 mm, 0.15 mm and 0.3 mm. Adjust the brake spacing approx. 0.2 mm by removing the
washer ©.
|T]
Checking the lamp terminal code
★The lamp terminal code O is provided at the back
of the control box. The AC 6 V lamp can be con¬
nected with this lamp terminal code.
CAUTION:
Be sure to wrap the end of the cord with tape after
disconnecting the lamp code.
Advertisement
Table of Contents
